Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul & Sabrina's cheap DIY 144v motor controller

MPaulHolmes · 10-04-2009, 04:24 PM

Holy cow, I wish I knew about that sucker before. I can supply you with the .HEX files, and you can do your worst! I don't know what software you can use to transfer the .HEX files. Maybe AVR Dude? I don't know. AVR Studio only lets you transfer files from specific devices made by Atmel I think.

Yes, you can program it in circuit. That's the 6 pin header on the control board. Pin 1 is MISO, Pin 2 is Vcc (5v), Pin 3 is SCK, Pin 4 is MOSI, Pin 5 is RESET, and Pin 6 is GROUND.

The AtMega8 is FLASH.

10-04-2009, 04:24 PM	#2361 (permalink)
MPaulHolmes PaulH Join Date: Feb 2008 Location: Seattle, WA Posts: 2,440 Michael's Electric Beetle - '71 Superbeetle 500000 Thanks: 306 Thanked 188 Times in 132 Posts	Holy cow, I wish I knew about that sucker before. I can supply you with the .HEX files, and you can do your worst! I don't know what software you can use to transfer the .HEX files. Maybe AVR Dude? I don't know. AVR Studio only lets you transfer files from specific devices made by Atmel I think. Yes, you can program it in circuit. That's the 6 pin header on the control board. Pin 1 is MISO, Pin 2 is Vcc (5v), Pin 3 is SCK, Pin 4 is MOSI, Pin 5 is RESET, and Pin 6 is GROUND. The AtMega8 is FLASH. (Support Ecomodder.com & get rid of these annoying ads!) __________________ signature goes here.