Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul and Sabrina's Cheap 3 Phase Inverter (AC Controller) with Field Oriented Control

motorulf · 01-04-2017, 01:47 PM

I had apparently mixed up the cables when i checked and fixed the pinout.
no 1 was going to 2 and vice versa.
Now things work better.
It does not run wild and i managed to complete a successful run-pi-test.
I saved
Then i tried run-pi-test2. now it is consuming 60Amps again. rotor vibrating and my thinner "fuse" cables melting. I aborted

(cut the power to everything)

I tried to power everything up again, when the contactor closes the motor starts vibrating and humming again, drawing 60 amps.

All the current sensors have connectors pointing towards the IGBT end of the cable.

Going forward though

Yeah, i am only using 25 volts right now, is that too low?

01-04-2017, 01:47 PM	#2981 (permalink)
motorulf EcoModding Lurker Join Date: Dec 2016 Location: northern sweden Posts: 33 Thanks: 17 Thanked 20 Times in 17 Posts	I had apparently mixed up the cables when i checked and fixed the pinout. no 1 was going to 2 and vice versa. Now things work better. It does not run wild and i managed to complete a successful run-pi-test. I saved Then i tried run-pi-test2. now it is consuming 60Amps again. rotor vibrating and my thinner "fuse" cables melting. I aborted (cut the power to everything) I tried to power everything up again, when the contactor closes the motor starts vibrating and humming again, drawing 60 amps. All the current sensors have connectors pointing towards the IGBT end of the cable. Going forward though Yeah, i am only using 25 volts right now, is that too low? Last edited by motorulf; 01-04-2017 at 01:58 PM..