Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul and Sabrina's Cheap 3 Phase Inverter (AC Controller) with Field Oriented Control

ScottyWarpNine · 11-17-2017, 11:30 AM

I have the PICkit plugged straight into the board, no extension cable.

I didn't notice it yesterday, but when I press the connect button to connect to the programmer, it gives me this error:

Target Device ID (0x0) is an Invalid Device ID. Please check your connections to the Target Device.

I tried pressing on the picket to try to get good connections on the programming headers but that didn't do anything.

I'll inspect my solder joints. It looks to me like it is a straight shot from the programming header to the dsPIC. Doesn't seem like a whole lot to go wrong.

I don't need the peripherals like throttle or encoder connected for programming, do I? the only connections I have to the board are power from a DC 24v supply, and the PICkit3.

11-17-2017, 11:30 AM	#3171 (permalink)
ScottyWarpNine EV Join Date: Jun 2017 Location: Akron, OH Posts: 12 Thanks: 4 Thanked 0 Times in 0 Posts	I have the PICkit plugged straight into the board, no extension cable. I didn't notice it yesterday, but when I press the connect button to connect to the programmer, it gives me this error: Target Device ID (0x0) is an Invalid Device ID. Please check your connections to the Target Device. I tried pressing on the picket to try to get good connections on the programming headers but that didn't do anything. I'll inspect my solder joints. It looks to me like it is a straight shot from the programming header to the dsPIC. Doesn't seem like a whole lot to go wrong. I don't need the peripherals like throttle or encoder connected for programming, do I? the only connections I have to the board are power from a DC 24v supply, and the PICkit3.