Go Back   EcoModder Forum > EcoModding > EcoModding Central
Register Now
 Register Now
 

Reply  Post New Thread
 
Submit Tools LinkBack Thread Tools
Old 09-12-2019, 12:29 PM   #261 (permalink)
Human Environmentalist
 
redpoint5's Avatar
 
Join Date: Aug 2010
Location: Oregon
Posts: 12,396

Acura TSX - '06 Acura TSX
90 day: 24.19 mpg (US)

Lafawnda - '01 Honda CBR600 F4i
90 day: 47.32 mpg (US)

Big Yeller - '98 Dodge Ram 2500 base
90 day: 21.82 mpg (US)

Prius Plug-in - '12 Toyota Prius Plug-in
90 day: 57.64 mpg (US)

Mazda CX-5 - '17 Mazda CX-5 Touring
90 day: 26.68 mpg (US)

Chevy ZR-2 - '03 Chevrolet S10 ZR2
90 day: 17.14 mpg (US)
Thanks: 4,192
Thanked 4,380 Times in 3,354 Posts
The silly thing with motorcycles is they use generators and shunt excess power generation to a heat sink. I'd like to shut my generator off too. I wonder how much power it robs from the engine? Probably should have done that during track days.

__________________
Gas and Electric Vehicle Cost of Ownership Calculator







Give me absolute safety, or give me death!
  Reply With Quote
Alt Today
Popular topics

Other popular topics in this forum...

   
Old 09-12-2019, 08:43 PM   #262 (permalink)
Master EcoModder
 
Join Date: Jan 2012
Location: United States
Posts: 1,756

spyder2 - '00 Toyota MR2 Spyder
Thanks: 104
Thanked 407 Times in 312 Posts
Quote:
Originally Posted by redpoint5 View Post
The silly thing with motorcycles is they use generators and shunt excess power generation to a heat sink. I'd like to shut my generator off too. I wonder how much power it robs from the engine? Probably should have done that during track days.
No, it uses PWM to short current through the stator to cancel out the rotor's magnetic field. That gives increasing copper losses as the rpms go up, but removes excess iron losses. The regulator itself is pretty efficient, and they could make it more efficient with bigger MOSFETs. If it used the regulator to burn off power that thing would go up in flames in seconds even if it had the biggest heatsink ever.

This control strategy is actually more efficient than an alternator up to a certain point, but the stator losses go up quadratically with speed due to the permanent magnet and start wrecking efficiency. I would guess that at the rev limit, a motorcycle generator is probably under 30% efficient vs. maybe 40% on a car alternator.

Since the stator is so undersized on a motorcycle, I think the highest efficiency option is to wire in a synchronous rectifier and DC-DC converter. I'm kinda curious how many motorcycles already have synchronous rectifiers, since you can use the same MOSFETs to do the PWM, so it would reduce the number of parts.

The actual best thing to do is to put in a bigger stator with lower winding resistance, but I'm guessing you'd need to do a lot of cutting to make that happen

Last edited by serialk11r; 09-12-2019 at 08:51 PM..
  Reply With Quote
The Following User Says Thank You to serialk11r For This Useful Post:
redpoint5 (09-13-2019)
Old 09-12-2019, 10:04 PM   #263 (permalink)
Master EcoModder
 
Ecky's Avatar
 
Join Date: Dec 2011
Location: New Zealand
Posts: 5,005

ND Miata - '15 Mazda MX-5 Special Package
90 day: 42.54 mpg (US)
Thanks: 2,866
Thanked 2,501 Times in 1,547 Posts
Quote:
Originally Posted by teoman View Post
Were you able to test the voltages?


I am talking to the chinese seller to work on my new order. And he sent me a picture saing new caps 650 usd, refurbished ones 135 usd. (Asking are these the ones)

So they are not new (despite the guy claimed they were in the beginning).

So, measured the caps and one of the end caps is a dead short. That's definitely not a great way to fail, a shorted cap will cause the other caps to go up in voltage and have a cascading failure. Eventually the whole thing becomes a short across the positive and negative terminals on the battery. I was lucky enough to actually be looking at the pack when it failed, and pulled it off when I saw the LEDs on the other balancing boards start to get brighter.

I wonder what caused the failure?
  Reply With Quote
Old 09-13-2019, 04:11 AM   #264 (permalink)
Master EcoModder
 
teoman's Avatar
 
Join Date: Jan 2017
Location: Istanbul
Posts: 1,245

A3 - '12 Audi A3
Thanks: 65
Thanked 225 Times in 186 Posts
Are the others at the same voltage?
  Reply With Quote
Old 09-13-2019, 06:18 AM   #265 (permalink)
Master EcoModder
 
Ecky's Avatar
 
Join Date: Dec 2011
Location: New Zealand
Posts: 5,005

ND Miata - '15 Mazda MX-5 Special Package
90 day: 42.54 mpg (US)
Thanks: 2,866
Thanked 2,501 Times in 1,547 Posts
Quote:
Originally Posted by teoman View Post
Are the others at the same voltage?
They're all still very close, yes.
  Reply With Quote
Old 12-23-2019, 01:24 AM   #266 (permalink)
EcoModding Lurker
 
Join Date: Sep 2017
Location: Australia
Posts: 22
Thanks: 0
Thanked 1 Time in 1 Post
Quote:
Originally Posted by Ecky View Post
I was under that impression as well. Hard to know what to make of all of the Amazon customer images of LiFePO4 batteries which caught on fire when they're not supposed to be able to.

https://www.amazon.com/Battery-Tende...70_&dpSrc=srch

Edit: my electrical theory is a bit weak but isn't it the case that since capacitors self-discharge, leaving one connected to the battery all the time would eventually drain it?
The self-discharge of capacitor bank is very small. I have charged an 83F one to 15 volts and left it standing. A week later it was at 13.8. The car itself would drain it a lot more than that. I have had such a capacitor bank and a LiFePo4 battery in my little Daihatsu Copen for nearly 2 years now, and it hasn't missed a beat. I happen to be blessed to live somewhere that doesn't freeze, so I don't have any concerns about charging. I did accidently flatten it once, though, and that is a problem. Some people gave me a push, and it wouldn't clutch start. I wasn't expecting that. I now have a jumpstart pack in the glove box, in case that ever happens again. No, I don't know either, where those pictures of flaming LiFePo4 batteries come from.
  Reply With Quote
Old 12-23-2019, 02:00 AM   #267 (permalink)
Human Environmentalist
 
redpoint5's Avatar
 
Join Date: Aug 2010
Location: Oregon
Posts: 12,396

Acura TSX - '06 Acura TSX
90 day: 24.19 mpg (US)

Lafawnda - '01 Honda CBR600 F4i
90 day: 47.32 mpg (US)

Big Yeller - '98 Dodge Ram 2500 base
90 day: 21.82 mpg (US)

Prius Plug-in - '12 Toyota Prius Plug-in
90 day: 57.64 mpg (US)

Mazda CX-5 - '17 Mazda CX-5 Touring
90 day: 26.68 mpg (US)

Chevy ZR-2 - '03 Chevrolet S10 ZR2
90 day: 17.14 mpg (US)
Thanks: 4,192
Thanked 4,380 Times in 3,354 Posts
Yes, just going to reiterate that caps don't self-discharge much. When they are near their rated voltage maximum, they will discharge at a higher rate, but I wouldn't call it fast. As they drop just a couple tenths of a volt, the self-discharge slows to a crawl. I've had caps with most of the voltage remaining 6 months after charging them, and that's with LED balancers on them. The LEDs themselves glowing for months.
__________________
Gas and Electric Vehicle Cost of Ownership Calculator







Give me absolute safety, or give me death!
  Reply With Quote
The Following User Says Thank You to redpoint5 For This Useful Post:
Daox (12-23-2019)
Old 12-23-2019, 05:07 AM   #268 (permalink)
Master EcoWalker
 
RedDevil's Avatar
 
Join Date: Dec 2012
Location: Nieuwegein, the Netherlands
Posts: 3,998

Red Devil - '11 Honda Insight Elegance
Team Honda
90 day: 47.72 mpg (US)
Thanks: 1,711
Thanked 2,245 Times in 1,454 Posts
Quote:
Originally Posted by freddyzdead View Post
... I did accidently flatten it once, though, and that is a problem. Some people gave me a push, and it wouldn't clutch start. I wasn't expecting that. I now have a jumpstart pack in the glove box, in case that ever happens again.
That's because the caps, once discharged, are at 0 Volt and will pull any power the alternator provides during the jump start down.
The LiFePO4 battery should have its own BMS to protect it.

Hooking up a separate jumpstart pack will bring it back up, but as the caps can draw near infinite amperage it needs to have some kind of current limiter.
__________________
2011 Honda Insight + HID, LEDs, tiny PV panel, extra brake pad return springs, neutral wheel alignment, 44/42 PSI (air), PHEV light (inop), tightened wheel nut.
lifetime FE over 0.2 Gmeter or 0.13 Mmile.


For confirmation go to people just like you.
For education go to people unlike yourself.
  Reply With Quote
Old 01-10-2020, 12:32 AM   #269 (permalink)
Master EcoModder
 
Join Date: May 2019
Location: California
Posts: 512

2020 - '08 Chevy Tahoe H
Last 3: 18.4 mpg (US)

2021 - '08 Chevy Tahoe H
90 day: 17.08 mpg (US)

2022 - '08 chevy Tahoe LT
Last 3: 14.38 mpg (US)

2023 - '08 Chevy Tahoe
90 day: 25.57 mpg (US)
Thanks: 2
Thanked 105 Times in 96 Posts
Quote:
Originally Posted by redpoint5 View Post
I have the supercap built, 1 battery (for proof of concept), 10 gauge copper wire, and a 300A breaker. The breaker might be rated a little too high, but I wanted to give myself the option of starting the vehicle using the battery if I wanted to, while still giving some protection against a short. I figure shorting a lithium-ion battery has fire potential, and with the battery living in the cabin, some precaution should be made. I might throw in a power resistor to limit current and then put a lower rated breaker or fuse for added safety. I'm not even sure if the 5Ah battery can supply 300A and trip the breaker. That's somewhere around 4,500 watts before the thing trips, assuming no voltage sag.

The test mule will be my Acura TSX.

I'll probably start a new thread if I get serious about this project, include some photos, a build description, and some data about various electrical draws that impact how long I can operate the car in "virtual alternator delete" mode.

Don't hold your breath; I have to find out where to live in a couple months, which might include buying a house. Lots of projects on my table, and I'm among the worst with time management (which is why I'm on here and not doing something useful).
you so crazy to use #10 with a 300amp breaker
or you just wanted a incandescent bulb under the hood?

you need at lest 4/0 wire for 300amp breaker (short run) longer runs will need 350 gauge wire(350 is a industrial sized wire)

trying to start a fire?

Last edited by Tahoe_Hybrid; 01-10-2020 at 12:38 AM..
  Reply With Quote
Old 01-10-2020, 03:01 PM   #270 (permalink)
Master EcoModder
 
Join Date: Dec 2010
Location: USA
Posts: 1,168

Sport Utility Prius - '10 Toyota Prius II
90 day: 52.98 mpg (US)

300k Sequoia 4WD - '01 Toyota Sequoia Limited 4wd
90 day: 20.19 mpg (US)
Thanks: 352
Thanked 265 Times in 212 Posts
Quote:
Originally Posted by Tahoe_Hybrid View Post
you so crazy to use #10 with a 300amp breaker
or you just wanted a incandescent bulb under the hood?

you need at lest 4/0 wire for 300amp breaker (short run) longer runs will need 350 gauge wire(350 is a industrial sized wire)

trying to start a fire?
Probably just too big. It will never ever even get close. The Prius hardly uses the 12v system.

__________________
"I feel like the bad decisions come into play when you trade too much of your time for money paying for things you can't really afford."
  Reply With Quote
Reply  Post New Thread


Thread Tools




Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com