Go Back   EcoModder Forum > Search Forums
Register Now
 Register Now
 

Showing results 1 to 13 of 13
Search took 0.00 seconds.
Search: Posts Made By: arber333
Forum: Fossil Fuel Free 12-27-2016, 03:28 AM
Replies: 3,480
Views: 915,938
Posted By arber333
Well i hope you all had merry christmas and i...

Well i hope you all had merry christmas and i wish you happy transition to new year 2017, to be close to your families and successful.



Right now i use 2x 100uF 800V in paralel. FFVE6B0107KJE...
Forum: Fossil Fuel Free 12-24-2016, 11:39 AM
Replies: 3,480
Views: 915,938
Posted By arber333
ok Paul I tried to test with motor as type 2...

ok Paul

I tried to test with motor as type 2
no luck so far. i can run PI test and motor spins a bit and then i get the value of Kp, Ki and PI.
When i try to start angle offset test nothing...
Forum: Fossil Fuel Free 12-18-2016, 12:20 PM
Replies: 3,480
Views: 915,938
Posted By arber333
Hi paul I have replaced drivers. I havent...

Hi paul

I have replaced drivers. I havent put PNP NPN transistors on yet. I wanted to try circuit without them first.
I connected EVERY emitter to common collector like you said. Unless there is...
Forum: Fossil Fuel Free 12-10-2016, 08:15 PM
Replies: 3,480
Views: 915,938
Posted By arber333
Well... i have it like this now: ...

Well... i have it like this now:

+12V-->EV200 coil+ --> EV200- -->small relay contacts-->GND
while i command small relay trough PCB relay ===> relay PCB+ --> relay PCB- -->GND
==> is actually...
Forum: Fossil Fuel Free 12-10-2016, 06:37 PM
Replies: 3,480
Views: 915,938
Posted By arber333
Inverter set

I have prepared inverter for motor start.
First i wired everything like it should be, tyco contactor and all, then i checked. It seems i always make mistake at wiring pedal... I have that written...
Forum: Fossil Fuel Free 12-08-2016, 06:56 PM
Replies: 3,480
Views: 915,938
Posted By arber333
I am sorry i havent got the meaning of wig wag...

I am sorry i havent got the meaning of wig wag throttle. I meant it as a boat throttle where one moves throttle back and eventually gets a backward movement. Not a good throttle in a car.
But what...
Forum: Fossil Fuel Free 12-05-2016, 09:13 AM
Replies: 3,480
Views: 915,938
Posted By arber333
Paul? I made encoder fitting and wiring. It...

Paul?

I made encoder fitting and wiring. It is open collector output so i have to setup pullup resistors for A, B, Z signal lines. Can you tell me if it would be better to put pullups to inverter...
Forum: Fossil Fuel Free 11-16-2016, 07:38 AM
Replies: 3,480
Views: 915,938
Posted By arber333
Leaf Blog

I will try to show how i assemble and test my inverter here. Later i will probably try to log my second car conversion. Have fun reading.

https://leafdriveblog.wordpress.com/
Forum: Fossil Fuel Free 11-10-2016, 07:51 AM
Replies: 3,480
Views: 915,938
Posted By arber333
Whohoho! Very good! Only 50A phase 96Vdc and no...

Whohoho! Very good! Only 50A phase 96Vdc and no shaking. I want to spin my motor now!!!

Seriously you should consider adding one switch to define direction. Put it on pin 10 maybe and we will...
Forum: Fossil Fuel Free 11-05-2016, 10:10 AM
Replies: 3,480
Views: 915,938
Posted By arber333
I decided to at least make a good box to mount...

I decided to at least make a good box to mount the hardware for inverter in it. Later i will adapt plugs and contacts to fit only from outside.
Check the brass rails and mounting of the main PCB.
...
Forum: Fossil Fuel Free 10-17-2016, 05:13 AM
Replies: 3,480
Views: 915,938
Posted By arber333
My Leaf controler build

Hi all

Ive been lurking some time now and reading this thread. Lots of info. I bought one PCB rev. 0 obviously and i built it to completion.

Like Paul said i will use 2x film caps 800V 100uF...
Forum: Open ReVolt: open source DC motor controller 11-16-2015, 11:00 AM
Replies: 143
Views: 42,639
Posted By arber333
Well system WAS designed with bottom balancing in...

Well system WAS designed with bottom balancing in mind. But on my insistence Neville changed code for top balancing - hence balancing switch. So if you dont want you can leave balancing off and...
Forum: Open ReVolt: open source DC motor controller 10-22-2013, 08:15 AM
Replies: 143
Views: 42,639
Posted By arber333
BMS Files

Anyone willing to make their own BMS. I prepared my iteration of files and documentation on Harlequin2s BMS on my website. Files are meaningfully named, though user manual is still written in...
Showing results 1 to 13 of 13

 
Forum Jump


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com