Go Back   EcoModder Forum > Search Forums
Register Now
 Register Now
 

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: stealth
Forum: Aerodynamics 10-18-2016, 03:36 PM
Replies: 57
Views: 17,326
Posted By stealth
Hello everyone, been a long time since the last...

Hello everyone, been a long time since the last post and a lot has happened since then. Over the summer, I have been built my new car and only just managed to make to the last three races including...
Forum: Aerodynamics 03-08-2016, 07:24 PM
Replies: 57
Views: 17,326
Posted By stealth
Sorry, I meant the F24 car with the outrigger,...

Sorry, I meant the F24 car with the outrigger, thanks for the info. Planning to have single speed at the moment for this car since it's easier to do and more reliable. In the future, I might swap out...
Forum: Aerodynamics 03-08-2016, 04:49 PM
Replies: 57
Views: 17,326
Posted By stealth
The camber is not for any steering or grip...

The camber is not for any steering or grip purposes, it only helps to reduce the frontal area significantly since a cambered wheel would take less space when in full lock than a noncambered wheel in...
Forum: Aerodynamics 03-05-2016, 06:23 PM
Replies: 57
Views: 17,326
Posted By stealth
Im having the front wheels running 10 degree...

Im having the front wheels running 10 degree negative camber and the rear at 7 degrees camber and I wouldn't find it safe at all if I started to modify the tyres especially if they are spinning...
Forum: Aerodynamics 03-01-2016, 04:56 PM
Replies: 57
Views: 17,326
Posted By stealth
I had a look at removing the inverted horn, and...

I had a look at removing the inverted horn, and it had odd effects on the drag figures. The front section has not been changed at all. On the model that has 100mm of ground clearance, flat base,...
Forum: Aerodynamics 02-28-2016, 08:17 PM
Replies: 57
Views: 17,326
Posted By stealth
Freebeard - Thanks, it's just coroplast, no...

Freebeard - Thanks, it's just coroplast, no aluminium skin or anything, it's a light material although difficult to shape. The second body was much easier, all done by hand, where as the first one,...
Forum: Aerodynamics 02-25-2016, 06:55 PM
Replies: 57
Views: 17,326
Posted By stealth
I used corroflute, which is a very light plastic...

I used corroflute, which is a very light plastic material and used Polyproplene hot glue to fasten the panels together on the inside and a strip of electrical tape.

The bezels are for reducing the...
Showing results 1 to 7 of 7

 
Forum Jump


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com