EcoModder.com - Search Results

Glossary

		EcoModder Forum > Search Forums
Search Results

Showing results 1 to 5 of 5
Search took 0.01 seconds. Search: Posts Made By: Don Gannon

Forum: Open ReVolt: open source DC motor controller

05-15-2018, 06:22 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,409,772

Posted By Don Gannon

OK I found these. 400v and 400a for $133.00...

OK I found these. 400v and 400a for $133.00 each. They have a bunch of them. Looks like these are usable, except what are pins on the end for?

CHNsalescom Welder repair Infineon FF400R06KE3...

Forum: Open ReVolt: open source DC motor controller

05-14-2018, 02:52 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,409,772

Posted By Don Gannon

No problem. As soon six o'clock gets here, I am...

No problem. As soon six o'clock gets here, I am gonna be an Amazon shopper for IGBTs.

Thank you for all the lessons you have taught me here. You and Paul and a few others have really inspired me...

Forum: Open ReVolt: open source DC motor controller

05-14-2018, 12:09 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,409,772

Posted By Don Gannon

Simply elegant. Very KISS. I can do this. Is...

Simply elegant. Very KISS. I can do this. Is that a separate DC to DC converter in the last two pics? The 12v to 24v mentioned in the earlier posts?

Forum: Open ReVolt: open source DC motor controller

05-14-2018, 09:07 AM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,409,772

Posted By Don Gannon

Nooooooooooo!

Thanks Piotrsko,

I need to go at least sixty (safe) miles on a charge. So I am now looking at ten 130 ah AGM 12 volt deep cycle batteries as the primary pack, and maybe six or eight more as a...

Forum: Open ReVolt: open source DC motor controller

05-13-2018, 06:35 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,409,772

Posted By Don Gannon

I want one!

Hi Paul,

I have been following this thread for several months now. Just registered to toss in a request for the new DC control board. Will the old one that is listed on your site work with the...

Showing results 1 to 5 of 5

Forum Jump