Go Back   EcoModder Forum > Search Forums
Register Now
 Register Now
 

Showing results 1 to 10 of 10
Search took 0.05 seconds.
Search: Posts Made By: plasticuser
Forum: Aerodynamics 02-01-2013, 09:25 AM
Replies: 35
Views: 8,048
Posted By GeekForLife
Make sure you use Bondo Gold, its what I use on...

Make sure you use Bondo Gold, its what I use on cabinets when there going to be lacquer finish. I thinly coat the entire surface and then lightly sand. The finish paint is so smooth you cant tell its...
Forum: Aerodynamics 02-01-2013, 07:42 AM
Replies: 35
Views: 8,048
Posted By bondo
It would be best to ask aerohead about the...

It would be best to ask aerohead about the rounded back end. A boat tail extension may be best that mounts on the lowered tailgate. That will get you another 24" back and then you can also haul 4x8...
Forum: Aerodynamics 01-31-2013, 05:37 PM
Replies: 35
Views: 8,048
Posted By bondo
The wire you are looking for is located under the...

The wire you are looking for is located under the drivers side door in the wiring harness against the frame. It will be a green wire with a black cap on it. Snip off the black cap and that is your...
Forum: DIY / How-to 01-26-2013, 09:29 AM
Replies: 12
Views: 13,272
Posted By elhigh
Hi, The rear's first option presents itself:...

Hi,
The rear's first option presents itself: you can clearly see the raising block that rides between the leaf spring and the axle. Take that thing out and you're down a couple of inches really...
Forum: DIY / How-to 01-24-2013, 10:34 AM
Replies: 12
Views: 13,272
Posted By Miller88
The part that allows the spring to expand is the...

The part that allows the spring to expand is the shackle. It is attached to the spring and pivots from a frame mount. A longer one should lower the truck.
Forum: DIY / How-to 01-23-2013, 03:59 PM
Replies: 12
Views: 13,272
Posted By Miller88
The rear is going to be easier than the front. ...

The rear is going to be easier than the front.

REAR
Check to see if it has lift blocks under the leaf spring. There's going to be a 1 or 2'' piece of steel (a block) between the leaf spring and...
Forum: EcoModding Central 01-18-2013, 10:16 PM
Replies: 12
Views: 5,658
Posted By GeekForLife
Front air dam

This weeks project a front air dam made from garden edging

First I measured the lowest piece under the truck
12281

Then I measured the front bumper clearance
12282

So it looks like I need...
Forum: Success Stories 12-04-2012, 05:31 PM
Replies: 51
Views: 17,063
Posted By RustyLugNut
I would continue to use the electric auxilliary lift pump.

Also, choose a pump that is cleanable and rebuild-able. I use the Facet electric pump that you can purchase through Pep Boys as it allows a simple clean out and rebuild. The pressure comes set from...
Forum: Success Stories 11-30-2012, 01:48 PM
Replies: 51
Views: 17,063
Posted By ChadB
MPGe is for converting alternative fueled vehicle...

MPGe is for converting alternative fueled vehicle fuel usage into numbers that make sense when comparing to gasoline vehicles; MilesPerGallonEquivalent. It has nothing to do with whether or not you...
Forum: Aerodynamics 09-19-2011, 06:01 PM
Replies: 802
Views: 665,522
Posted By basjoos
That is a photo of the Coroplast prototype nose...

That is a photo of the Coroplast prototype nose along with the hood attachment points for the second windshield I was testing at the time. Of course it is butt ugly with those slabs of Coroplast. ...
Showing results 1 to 10 of 10

 
Forum Jump


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com