Go Back   EcoModder Forum > Search Forums
Reload this Page Search Results
Register Now
 Register Now
 

Showing results 1 to 16 of 16
Search took 0.05 seconds. Search: Posts Made By: Ironside
Forum: Motorcycles / Scooters 10-11-2020, 07:13 AM
Replies: 179
Views: 73,477
Posted By C90MG
-Do you have a thread on the c90 forum anywhere? ...

-Do you have a thread on the c90 forum anywhere?
-the windscreen lexan, where can I get some in the uk? the small half moon ones I've made from polycarb stuff from homebase is no good.....
-would...
Forum: Motorcycles / Scooters 02-19-2019, 03:08 PM
Replies: 179
Views: 73,477
Posted By Stubby79
Just tested mine with a timing light...the timing...

Just tested mine with a timing light...the timing mark barely moved as I revved it up. Disappointing, and a bit inconclusive. Might have gained like 5 degrees, between idle and probably 6 to 8k rpm....
Forum: Motorcycles / Scooters 02-19-2019, 11:10 AM
Replies: 179
Views: 73,477
Posted By Stubby79
I have experience with them, but not with trying...

I have experience with them, but not with trying to advance the timing. It wouldn’t surprise me that they have fixed timing...I was looking at the signal generator, and wondered how it advanced the...
Forum: Motorcycles / Scooters 10-26-2018, 01:42 AM
Replies: 6
Views: 1,282
Posted By Michael Moore
Royal Enfield "Dreamliner"

There's a copy of the short article on it by Vic Willoughby here:

http://www.eurospares.com/graphics/aero/Dreamliner.pdf

Built in 1956 the data table at the end shows that aerodynamics can have...
Forum: Motorcycles / Scooters 04-06-2017, 04:23 PM
Replies: 179
Views: 73,477
Posted By seifrob
Cellphone accessory shops advertise here glass...

Cellphone accessory shops advertise here glass treatment. Its either scratch resistant foil or kind of ?resin? that hardens andakes the glass scratch resistant.maybe to ask to harden your windshield...
Forum: Motorcycles / Scooters 02-27-2017, 05:57 PM
Replies: 385
Views: 193,027
Posted By visionary
Further news

This is an interim update - end of Feb 2017 which is already a month behind my schedule for the next step video

But i have an excuse!
I thought I would finish some of the bodywork
It will look...
Forum: Motorcycles / Scooters 04-25-2016, 06:17 PM
Replies: 385
Views: 193,027
Posted By visionary
Update 21 Still working at it! Although my...

Update 21 Still working at it!

Although my rate of posting updates has fallen off (apologies to those following) I have been able to maintain a regular pace of work, which I suppose averages out...
Forum: Motorcycles / Scooters 01-05-2016, 09:33 PM
Replies: 72
Views: 19,214
Posted By MVetter
Why yes, I have. I hadn't thought about this...

Why yes, I have. I hadn't thought about this thread much but then I get the email alert when people post so I thought I'd give a bit of an update.

Dad came home later October and has been a bit...
Forum: Motorcycles / Scooters 01-15-2015, 06:35 AM
Replies: 1
Views: 1,145
Posted By PeterS
A page of good links.

This has probably been posted before but here it goes again. The Recumbent Bicycle and Human Powered Vehicle Information Center (http://www.recumbents.com/wisil/whatsup.htm)
It's all recumbent...
Forum: Motorcycles / Scooters 06-19-2014, 06:15 AM
Replies: 179
Views: 73,477
Posted By sendler
Fitting the Innova F.I. might not work well. Even...

Fitting the Innova F.I. might not work well. Even if the Honda donor F.I. has an O2 sensor, the computer has a limited range to adapt the mixture. And only in a few global operational ranges. The...
Forum: Motorcycles / Scooters 03-25-2014, 05:39 PM
Replies: 180
Views: 38,290
Posted By sendler
Most of this has been well discussed in the...

Most of this has been well discussed in the "windy slope" thread:
.
http://ecomodder.com/forum/showthread.php/motorcycle-aerodynamics-slippery-windy-slope-16754-14.html#post285297
Forum: Motorcycles / Scooters 03-19-2014, 02:24 AM
Replies: 180
Views: 38,290
Posted By Otto
Try clear plastic L shaped corner piece used to...

Try clear plastic L shaped corner piece used to protect corners of sheetrock walls in houses. Comes in 8' lengths, straight but somewhat flexible.

Very cheap at Home Depot or Lowes. Stick on...
Forum: Motorcycles / Scooters 03-05-2014, 02:11 AM
Replies: 180
Views: 38,290
Posted By Teri_TX
Dutch advances

Since Theo22 has been shy about posting in the discussion, I'll just spill the beans.

In PM's with Theo22, he basically confirmed they have been using stall strips on their human powered...
Forum: Motorcycles / Scooters 01-22-2014, 01:56 PM
Replies: 179
Views: 73,477
Posted By PaulBlez
Enclosing a Piaggio MP3: Already done in Belgium

Not really. It would be a very brave man (or woman) who did not leave themselves the option of putting a foot down with an enclosed MP3.
You can see from this photo that my Belgian friend Steve Van...
Forum: Motorcycles / Scooters 01-06-2014, 12:01 PM
Replies: 385
Views: 193,027
Posted By Frank Lee
Love your Cub, Ironside. :thumbup: Wish I could...

Love your Cub, Ironside. :thumbup: Wish I could see it in person and take it for a spin. That is the bike I've been wanting for such a long time. The U.S. is alone in the world for not having access...
Forum: Motorcycles / Scooters 07-11-2012, 01:14 PM
Replies: 65
Views: 135,504
Posted By euromodder
I think Allert is pretty busy with his company. ...

I think Allert is pretty busy with his company.
Velomobiel are building an additional production facility in Breaza, Romania.
Their product range is also expanding - filling niches in what is...
Showing results 1 to 16 of 16

 
Forum Jump

Contact Us - EcoModder.com - Archive - Recent Posts - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com