2003 Ford Ranger - Begin modding!
Hello people, I have decided to begin aeromodding my 2003 ford ranger. First, I'm going to design a partial grill block. Second I'm going to cover the fog lights and design an underbody panel. Finally, I'm going to design moon caps for my wheels. Any beginning ideas?
|
Hope you can snag some of those Coroplast political signs before they all git recycled. ;)
Look at my belly pan thread to git some ideas on yer belly pan design. Under belly pan... - Toyota Nation Forum : Toyota Car and Truck Forums |
Are you only into aeromodding, not considering some weight-saving? BTW I'd not use coroplast for a belly pan, I'd rather use either aluminum or plywood (since it's used in some racing cars too) to avoid heat damage.
|
Get real Moon™ wheel disks. I got a set of 4 at a swap-meet for $5 because the mounting holes had been worn out into notches on the edge. Three new holes and good to go.
|
Well I'm new to ecomodding. I have an obnoxious grille that needs to be cleaned up and made more aerodynamic. I haven't decided what I'm fully going to do with the truck, but I'm going to improve the gas mileage as much as possible because it's only got 20000 miles, and I imagine I'm going to put over 200,000 on it.
|
Quote:
|
Quote:
Modified air dam... - Toyota Nation Forum : Toyota Car and Truck Forums |
Alright, I have a temporary partial grille block installed. what do you guys think?
|
bump
|
|
All times are GMT -4. The time now is 09:12 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com