Any DashDyno users here?/Additive testing
I've seen a lot of posts regarding Scan Guage and others and I realize DD is kind of expensive, but I bought one because of the logging and dyno functions.
I have developed a fuel additive that boosts HP and logically would increase mileage (if driven "normally") and like any MPG mod, should decrease overall emissions/mile (which was the intent of creating it). EPA registered for 3 years now. Gas or diesel or E-85. I'm looking for advice which OBD functions would be the best choice for logging to evaluate fuel economy. I can log up to 16 items. I can log MAF or MAP derived instant and average MPG, load, RPM, LT/FT fuel trim, mph, or any thing else the OBD will provide. I would also like to offer any Austin, TX area DashDyno owner a free sample for testing (about 3 months worth), if you'll share your data. Also would like to provide it to experts on this forum who are open to giving their honest objective/subjective evaluation of it. Preferably with data. Because it is flammable, it has to go by (UPS) ground if shipped anywhere and that's why I don't have a buy button on my site. I just haven't worked out logistics for practical shipping of the small amounts used by individual consumers. Open to suggestion on that topic as well! |
|
Quote:
Again, what I need are the best things to log for fuel economy analysis and possibly advice from DD users, as I have not mastered the device. Any tips on that might be useful. I have RTFM, but it is understandably written more for performance users. |
A racer would say: put it on a dyno. (A real dyno, to mininize as much variability as possible.)
That's what I would say too. |
You already said you can monitor instant and average MPG, that is what you would need to evaluate fuel economy. You should be able to monitor ignition timing as well.
All of this research is not really worth it for fuel economy concerns, because the increased fuel economy (if any) will not offset the additional cost of buying your product. |
4 Attachment(s)
Quote:
I didn't get the hard copies, but I did get some (crappy) screen captures from the video at the end of the session. I had the camera focused on the gas analyzer as we were testing it under load, but it made the hair stand up on the back of my neck when we ran the second dyno test (the first one with the additive in) and I rushed to the gas station to get more gas to mix more in. 10/18/2010. The tech asked me if I had put "liquid dynamite" in it. I'm assuming he meant nitroglycerine. BTW, it would have taken 4 gallons of nitromethane in 16 gal. of gas to get the results I got with 4 mL of the additive. I made it stronger since then. The Dash Dyno duplicates the curves of the "real" DynoJet chassis dyno almost perfectly, but it's a pita to enter in all the info. I seldom have the barometric pressure data, frontal area, etc. available to me. |
Quote:
I'd still like to find the "sweet spot" for my '99 Ranger 2.5L I'd still Like to figure it out even though I don't drive much and use about 15 gallons of fuel a month. Every dollar counts for me. Watching the instant mileage is amusing, but watching the speedometer and the road is more important to me. |
All times are GMT -4. The time now is 09:16 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com