Go Back   EcoModder Forum > EcoModding > EcoModding Central
Register Now
 Register Now
 

Reply  Post New Thread
 
Submit Tools LinkBack Thread Tools
Old 10-09-2010, 07:00 AM   #1 (permalink)
Wiki Writer
 
Join Date: Jul 2010
Location: Melbourne, Australia
Posts: 236

bugler - '91 Mazda 626
90 day: 35.89 mpg (US)
Thanks: 15
Thanked 25 Times in 22 Posts
Antenna, how to make a DIY internal or aerodynamic external antenna

Hi all,
I have taken out my antenna today, it has always annoyed me using power when it goes up and down and the aerodynamic drag so after several hours of working out how to get the damn thing out of the car its finally out. So now its out im trying to work out how to best get reception back.

I tried just a length of wire routed around my car cabin but the reception isn't great. I remember seeing a few RF people on the forum so i thought id ask what are the important things to consider when making a "DIY" antenna

So a few questions/statements to get the ideas flowing
- Will just a piece of wire work as good as a telescoping antenna?, i can still use the telescoping antenna and mount it inside the cabin.
- I have to assume internal antennas are going to pick up less signal compared to external since the car metal work is earthed. Would it be better to run a wire around the top of the roof where it isn't shielded.
- The length of the aerial is important, quarter, half or full wavelength is ideal. Anywhere inbetween and the signal is not ideal i assume this is for resonance but im a bit rusty on my RF theory.
- Does the Length of aerial need to be all in one direction, can say a 1 meter aerial be half meter long one way and half meter long at 90 degrees. (asking so i can wrap it around in the cabin) I could have a full wavelength of wire and have it routed around the cabin roof, a quarter wavelength on each side of the cabin roof.
- Should the antenna be ideally sticking upward instead of going along the roof line, if so is there much signal reduction because of bad orientation
- Should coax cable with shield connected at both ends be used all the way up to the point where the antenna (or wire) starts.

I haven't really tried to match the antenna length yet or orient the wire properly but im still picking up a few radio stations with just a random piece of wire shoved into the antenna plug. So i figure with a few pointers i might be able to get normal reception fairly easily.

  Reply With Quote
Alt Today
Popular topics

Other popular topics in this forum...

   
Old 10-09-2010, 09:48 AM   #2 (permalink)
Administrator
 
Daox's Avatar
 
Join Date: Dec 2007
Location: Germantown, WI
Posts: 11,203

CM400E - '81 Honda CM400E
90 day: 51.49 mpg (US)

Daox's Grey Prius - '04 Toyota Prius
Team Toyota
90 day: 49.53 mpg (US)

Daox's Insight - '00 Honda Insight
90 day: 64.33 mpg (US)

Swarthy - '14 Mitsubishi Mirage DE
Mitsubishi
90 day: 56.69 mpg (US)

Daox's Volt - '13 Chevrolet Volt
Thanks: 2,501
Thanked 2,585 Times in 1,553 Posts
I'm interested in this as well. I was just about to replace my broken antenna and looked at internal ones. If I could DIY all the better!
__________________
Current project: A better alternator delete
  Reply With Quote
Old 10-09-2010, 10:24 AM   #3 (permalink)
Banned
 
Join Date: Feb 2008
Location: california
Posts: 1,329
Thanks: 24
Thanked 161 Times in 107 Posts
I hooked up the antenna wire to the rear window defogger. It has great reception. The defogger is disabled now (disconnected at both ends) but its not an issue because the tint on the inside of the windows seems to prevent that from happening. The defogger button and circuit and be reused for other purposes. I use it to go between a FE and power fuel table in MS.

Last edited by tjts1; 10-09-2010 at 10:32 AM..
  Reply With Quote
Old 10-09-2010, 11:59 AM   #4 (permalink)
Pokémoderator
 
cfg83's Avatar
 
Join Date: Dec 2007
Location: Southern California
Posts: 5,864

1999 Saturn SW2 - '99 Saturn SW2 Wagon
Team Saturn
90 day: 40.49 mpg (US)
Thanks: 439
Thanked 530 Times in 356 Posts
tjts1 -

I always wanted to do that but never got around to it. I pulled the fuse of the rear defogger in preparation, but I didn't do the next step of figuring out where to hook into it. I was going to hook into one of the connectors where the fuse was, but I have to make sure I don't connect it to the "hot" connector, or I'll fry my radio.

CarloSW2
__________________

What's your EPA MPG? Go Here and find out!
American Solar Energy Society
  Reply With Quote
Old 10-09-2010, 03:43 PM   #5 (permalink)
Master EcoModder
 
Zerohour's Avatar
 
Join Date: Jul 2010
Location: PA
Posts: 314

Pooparu - '01 Subaru Outback Limited
90 day: 28.12 mpg (US)

Cop Car - '94 Chevy Caprice Interceptor 9C1
Last 3: 18.48 mpg (US)

Mini - '11 Mini Cooper
90 day: 37.63 mpg (US)

Gramps - '95 Subaru Legacy Postal
90 day: 23.18 mpg (US)
Thanks: 10
Thanked 17 Times in 10 Posts
I shaved the antenna on my 86 Cavalier. Removed the front fender, arched the antenna over the wheel well. Patched the antenna hole, painted the fender, reinstalled. Somehow it didn't effect the reception of the local stations. But the Factory GM radio/antenna setup never picked up anything beyond the local broadcasts. Might be larger effect on a more modern radio that has better reception.
__________________
  Reply With Quote
Old 10-09-2010, 04:43 PM   #6 (permalink)
Left Lane Ecodriver
 
RobertSmalls's Avatar
 
Join Date: Aug 2008
Location: Buffalo, NY, USA
Posts: 2,257

Prius C - '12 Toyota Prius C
Thanks: 79
Thanked 286 Times in 199 Posts
I was going to install a 95cm (=100MHz quarter-wave) antenna under a plastic or fiberglass body panel, but the stock antenna located inside the car is doing an adequate job. The stock antenna is about 40cm long, and is powered. Correction: it was powered.
  Reply With Quote
Old 10-09-2010, 05:16 PM   #7 (permalink)
Wannabe greenie
 
Join Date: Aug 2008
Location: Yorba Linda, CA
Posts: 1,098

The Clunker (retired) - '90 Honda Accord EX sedan
Team Honda
90 day: 29.49 mpg (US)

Mountain Goat - '96 Ford Ranger XLT 4x4 SuperCab
90 day: 18 mpg (US)

Zippy - '10 Kymco Agility 125
90 day: 65.03 mpg (US)
Thanks: 5
Thanked 53 Times in 40 Posts
I thought I remembered reading here about somebody who took a regular car antenna and stuck it behind the plastic trim piece on the A-pillar. If I actually cared about radio reception, I'd probably try that.
__________________

  Reply With Quote
Old 10-09-2010, 07:57 PM   #8 (permalink)
Gen II Prianista
 
Rokeby's Avatar
 
Join Date: Jul 2009
Location: Ballamer, Merlin
Posts: 453
Thanks: 201
Thanked 146 Times in 89 Posts
Here are two possible solutions that mount to the inside of the windshield,
~$20:

I know they aren't DIY, but hey, only $20, could save a lot of hassel!

Universal Am-Fm Hidden Windshield Antenna : eBay Motors

Interior Antenna AM/FM glass mount Road Rage: eBay Motors

Other possible solutions by Googling, "inside car am/fm antenna".

Good luck!

Last edited by Rokeby; 10-09-2010 at 08:06 PM..
  Reply With Quote
Old 10-09-2010, 08:47 PM   #9 (permalink)
Pokémoderator
 
cfg83's Avatar
 
Join Date: Dec 2007
Location: Southern California
Posts: 5,864

1999 Saturn SW2 - '99 Saturn SW2 Wagon
Team Saturn
90 day: 40.49 mpg (US)
Thanks: 439
Thanked 530 Times in 356 Posts
Clev -

Quote:
Originally Posted by Clev View Post
I thought I remembered reading here about somebody who took a regular car antenna and stuck it behind the plastic trim piece on the A-pillar. If I actually cared about radio reception, I'd probably try that.
I did this one, which is what you are descrobing :

Free Stealth Antenna Mod w/ Pics - SaturnFans Forums

The reception is not as good as it was. I think I should have "sheathed" the antenna in heat-shrink tubing.

CarloSW2
__________________

What's your EPA MPG? Go Here and find out!
American Solar Energy Society
  Reply With Quote
Old 10-09-2010, 10:02 PM   #10 (permalink)
Banned
 
Join Date: Feb 2008
Location: california
Posts: 1,329
Thanks: 24
Thanked 161 Times in 107 Posts
Quote:
Originally Posted by cfg83 View Post
tjts1 -

I always wanted to do that but never got around to it. I pulled the fuse of the rear defogger in preparation, but I didn't do the next step of figuring out where to hook into it. I was going to hook into one of the connectors where the fuse was, but I have to make sure I don't connect it to the "hot" connector, or I'll fry my radio.

CarloSW2
I connected the antenna wire directly to the defogger on the window. It has 2 small plugs, one on each side of the window. Other cars might be different but usually there is a pretty simple plug glued to the glass.
good luck
Justin


Last edited by tjts1; 10-09-2010 at 10:08 PM..
  Reply With Quote
Reply  Post New Thread


Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
DIY: OEM VX PCV and Info TomO DIY / How-to 4 04-02-2011 09:38 AM
how to make a DIY hybrid 2010 Corolla S? GenX Rolla Hybrids 8 08-22-2009 10:51 PM
Home Brew Challenge for Electric Geniuses (make a DIY electric motor controller) WaxyChicken Off-Topic Tech 42 08-19-2008 01:05 AM
DIY - Removing Your Radio Antenna SVOboy DIY / How-to 27 07-07-2008 07:38 PM
DIY: Make a PVC Catch Can for your PCV System TomO DIY / How-to 0 11-14-2007 03:30 PM



Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com