Programming an Open Revolt controller
Hello all! It's been far, far, faaaaar too long. But I've been around, and I'm here again.
I'm partially through assembly of a 1000 amp IGBT controller, just the same as I was 2 years ago (gasp! Has it been that long!?). What's the current firmware? If I'm programming via USBtinyISP and avrdude, what file do I need? A .hex, .c, or .h? My chip is 100% raw. Do I need a bootloader? I have this board (not that it matters): https://lh6.googleusercontent.com/-6...G_00000049.jpg |
Pls excuse me going offtopic but isn't this the first public appearance of "new" control board? Or am I a bit "outdated" and there're some other pictures/schematics somewhere?
|
This board was a 1kA run produced near the beginning of 2011, actually.
|
Quote:
I think this is what I used. It has been a while. avrdude needs to point to where the file is first. avrdude -p m8 -c sp12 -P lpt1 -e -U flash:w:coug-unified-16km8.hex RTD Explorer works easier. |
RTD may work easier, but I don't have my serial port up and running yet - and the chip is a raw chip.
I think I've got it ready to go... https://lh6.googleusercontent.com/-7...rogramming.PNG |
I like how it thanks you at the end.
That's some polite electronics! :thumbup: |
|
All times are GMT -4. The time now is 06:16 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com