Scangauge gone insane

[bryan11]

When filling up this morning for the first time after a reset, the fillup gallons estimated was 19.2 gallons. My tank size is set at 13 gallons. This can't be right.

I issued another reset command telling the scangauge to use defaults, then set tank and engine size again. When setting defaults, the scangauge sometimes freezes for a couple seconds and then returns to the 'home' screen. Is this normal?

After finishing the setup, I tried to tell it I'd just finished a fillup. Again, default was 19.2 gallons? WTF?

[bryan11]

Well, Linear Logic, LLC got back to me almost immediately when I e-mailed them today. It sounds like I'm reading too much into the inital 'gallons used' value after reset and all will work out fine after a few fillups.

+1 to the Scangauge makers for helping out a customer at internet speed. With this kind of support, I won't hesitate to by another Scangauge for other vehicles.

[gone-ot]

+1, "Good People = Good Service."