Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul & Sabrina's cheap DIY 144v motor controller

edown · 05-04-2009, 03:31 PM

OK, a few close ups.. Yes the M- bar is 2 bars (1"x.25") with 1/2" OD tube soldered in, with a steel manifold at the end.. FETs are soldered to .016 copper sheet.. I use a small acetylene torch to solder the FETs and diodes in.. (quickly)

05-04-2009, 03:31 PM	#1136 (permalink)
edown EvEagle Join Date: Apr 2009 Location: Lansing, MI Posts: 40 Thanks: 0 Thanked 7 Times in 4 Posts	OK, a few close ups.. Yes the M- bar is 2 bars (1"x.25") with 1/2" OD tube soldered in, with a steel manifold at the end.. FETs are soldered to .016 copper sheet.. I use a small acetylene torch to solder the FETs and diodes in.. (quickly)