Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul & Sabrina's cheap DIY 144v motor controller

Wherewolf · 09-08-2009, 12:22 AM

It worked out to about $30 per board if we order a sheet of 6oz....and have it cut to size. That was based on 6x9 inch board - different sizes would be different prices depending on the final amount of cuts. But it would be 36x48 so someone with a large CNC could mill the entire thing and then cut it. We had kicked the idea around a long time back. It's about a 2 week or so lead time - shipping cost would depend on if we had it cut by the board house, or shipped it whole....let me know if anyone wants to pursue this line of thinking....

Wherewolf

edit: Oh yeah...instead of wrenching on electric conversion today, I got tired of lugging my welder and plasma torch around...so I decided to build a cart for them...and then; as usual; things got a little out of hand....
24 volt powered welderchair anyone?
Betcha never seen one of these.....

(24VDC drive - the welder and plasma torch still need 220VAC, just in case anyone was wondering....)

09-08-2009, 12:22 AM	#2246 (permalink)
Wherewolf EcoModding Lurker Join Date: Apr 2009 Location: Oryeegone Posts: 28 Thanks: 0 Thanked 1 Time in 1 Post	It worked out to about $30 per board if we order a sheet of 6oz....and have it cut to size. That was based on 6x9 inch board - different sizes would be different prices depending on the final amount of cuts. But it would be 36x48 so someone with a large CNC could mill the entire thing and then cut it. We had kicked the idea around a long time back. It's about a 2 week or so lead time - shipping cost would depend on if we had it cut by the board house, or shipped it whole....let me know if anyone wants to pursue this line of thinking.... Wherewolf edit: Oh yeah...instead of wrenching on electric conversion today, I got tired of lugging my welder and plasma torch around...so I decided to build a cart for them...and then; as usual; things got a little out of hand.... 24 volt powered welderchair anyone? Betcha never seen one of these..... (24VDC drive - the welder and plasma torch still need 220VAC, just in case anyone was wondering....) Attached Thumbnails Last edited by Wherewolf; 09-08-2009 at 01:08 AM..