Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul & Sabrina's cheap DIY 144v motor controller

jackbauer · 11-19-2009, 06:12 PM

Thanks Paul

Its running with the 8mhz crystal , 8khz switching. Only a little noise at low current. I wouldn't have noticed if I wasn't looking. Heatsink stayed below 24c throughout the whole run and at 24v it would have to draw a lot of amps! I must have a look at getting the v1.1 firmware to run at 8mhz.

11-19-2009, 06:12 PM	#2594 (permalink)
jackbauer Master EcoModder Join Date: Sep 2009 Location: Ireland Posts: 734 Thanks: 26 Thanked 304 Times in 171 Posts	Thanks Paul Its running with the 8mhz crystal , 8khz switching. Only a little noise at low current. I wouldn't have noticed if I wasn't looking. Heatsink stayed below 24c throughout the whole run and at 24v it would have to draw a lot of amps! I must have a look at getting the v1.1 firmware to run at 8mhz.