Quote:
Originally Posted by MPaulHolmes
hahaha.
OK, I finished the SR control board. It will work this time, or my name is aunt Hilda! I just submitted it to PCB International, which offered to try to convert the PCB Artist file!!!
|
Congratulations! thats great news. I'm very much looking forward to the CAN Bus based boards.
Quote:
Originally Posted by MPaulHolmes
My skin started to smoke immediately! It smelled super good! But then it hurt really bad.
|
Hope it heals fast.
Enjoy your WELL DESERVED holiday!
I found this while browsing at work sure looks cool.
its a Atmel AT90CAN128, so it has CAN, RS232, I2C, 128kb and can be spec'ed up to include an SD card module. with case. I think i just found my display interface for the car! will be much like the Apexi PowerFC Hand controller. We could use these to configure the open source controller, charger and BMS, as well as display with various modes. The setup would be <$200USD. VERY cool IMO.
I spent a bit of time reading up on CAN. I can't wait for CAN and the modularity it will provide, as its exactly what i've been waiting for...