[Sulfuric]

After partial satisfaction with my partial boat tail, I think I'm going to make some front wheels skirts too. I want to use a hinge, drilled directly above the wheel well, and then use some aluminum for the main material. I am definitely worried about rubbing, but I dont have time to get any rollers from that web site that basjoos mentioned in the metrompg front wheel skirts thread . . . Anyway, I'm hoping that I can curve it out just a little so it only rubs against my tires with very sharp turns.

Any advice would greatly appreciated, as I only have a few days before my ecomodding is finished until . . . the winter holidays, and I plan on doing these tomorrow.