Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul & Sabrina's cheap DIY 144v motor controller

twotires · 01-12-2011, 04:04 PM

Uh-oh ... I already soldered in a MAX232. Do I need to swap out C7, C8, C9, C10, and C12 to 1uFs instead of 0.1uFs?

Also, the 9-Pin sub-D Female serial connector needs to be added to the BOM, and the 5-Pin Molex connector and pins can be removed, I think.

Most people don't install that 5-Pin connector, do they?

Now I wish I had taken time to read all 423 pages of this thread!

01-12-2011, 04:04 PM	#4197 (permalink)
twotires EcoModding Noob Join Date: Dec 2010 Location: Raleigh, NC, USA Posts: 24 Thanks: 9 Thanked 4 Times in 3 Posts	Uh-oh ... I already soldered in a MAX232. Do I need to swap out C7, C8, C9, C10, and C12 to 1uFs instead of 0.1uFs? Also, the 9-Pin sub-D Female serial connector needs to be added to the BOM, and the 5-Pin Molex connector and pins can be removed, I think. Most people don't install that 5-Pin connector, do they? Now I wish I had taken time to read all 423 pages of this thread!