|
I officially updated the numbers on the boards with pcbcart. Hurray.
Also, I wrote some gcode, and made 3 etched boards with a couple holes in each one so it will bolt right onto a bus bar. I also soldered a little high magnetic field current sensor to one of them. It's ready for testing with the 3/8" x 3/4" bus bar. But the stupid bus bar isn't here yet! They are being shipped all the way from Seattle! I sure hope UPS delivers on Saturdays, or bam! right in the eyeball.
I think I used the wrong kind of flux on the practice current sensor, so this one will probably not be used in any final controller.
|