Quote:
Originally Posted by Daox
. . .
Anyway, I finished up the temperature hack shield this morning. I did make a small change to the schematic. To reduce the amount of resistors needed I put just one 560 ohm resistor before all of the resistors.
. . .
|
I would expect the LED intensity to be a function of how many LEDs are on at one time. The original circuit would keep the LED currents identical for any combination. However, if only one LED is expected to be at a time, it is a good hack.
BTW, one thing I did with my hack was to have the LED blink in proportion to different diagnostic modes.
GOOD LUCK!
Bob Wilson