Do you have any more of these boards? I have been out of the loop on this forum for some time, so I am trying to catch up.
I was looking for 1000 amp capability.
Quote:
Originally Posted by mrbigh
Finally I have the parts that do go along the IGBT driver board for the Paul & Sabrina revolt controller board. Based on Powerex electrical design and Paul's PCB art layout.
I will be supplying the bare PCB and the PC board with almost all parts, excluding the VLA500-01 and the 2 gate power resistors.
Gate resistors (R3 and R7) depend on the preferred IGBT to be use, values will be in the range of 1.5 to 12 Ohms, 2 Watts dissipation.
Parts will be supplied populated on the board but unsolder to minimize parts bagging, labeling and placement mistake.
The parts kit:
6 Zenner diodes
2 Ultra fast recovery diodes
5 resistors
2 Optoisolators
5 electrolytic cap.
2 right angle connector headers
1 straight connector header
3 header connector sockets
12 gold crimp/solder pins
All parts distribution will be handled by USPS flat rate mailers in continental USA.
International orders are welcome, inquire whiting.
Payment will be through PAYPAL.
|