Quote:
Originally Posted by 3-Wheeler
Hi,
Your new template would seem to have a length/width ratio less than the minimum of 2.5:1 set by AeroHead.
Any thoughts on how you arrived at this length?
Jim.
|
Hey Jim,
There is no width ("d" in 2.5d on "Aerodynamic Streamlining Template") in my sketch.
The idea was to overlay the new and old one for comparison- to see if there's much difference. Now that I think about it again, the first sketch seems correct because I aligned the heights as one would with the AST to scale it to a vehicle.
I will wait to see what AeroHead says, but I figured that comparison was a first step that could be done in an attempt to help.
Thanks,
Kurt