e*clipse!! I found the old PCB schematic!! I bet the software could very quickly be adapted to it. Just rename a few pins. I did have the V/Hz code working someplace. I don't know where, but it was on an even older board. I think it would be easier to start where I am now and change it to fit that board instead. but this only has FOC code on it at the moment. but the V/Hz was just a big lookup table, and then racing through the table at a given frequency.
I think Q3 needs to be rotated 180 degrees and resoldered.
Last edited by MPaulHolmes; 09-14-2015 at 07:39 PM..
|