Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post

CFECO · 10-05-2015, 08:35 PM

HI, I am designing and rounding up parts to build an Electric, two seat, 4 wheel light Utility Vehicle. I'm going to use two motorcycles for the suspensions, and I want to start with the 48 volt Club Car motor I have ( I think, it's been so long since I saw it). I obviously need a shaft and bearing plate for the motor, if that is something you could make, I'd love to discuss it! I will probably direct mount it to a small differential with a flex coupling, so it doesn't need to take chain stress ( outer bearing). I have a thread on my project, it's at Fossil Fuel Free..."I want a Hybrid Side by Side". Hope to hear from you soon!

10-05-2015, 08:35 PM	#5 (permalink)
CFECO CFECO Join Date: May 2008 Location: Vail, AZ. Posts: 552 X-Car - '11 Homemade 2+2 Velbly1 - '17 Toyota Camery XSE 90 day: 29 mpg (US) Velbly2 - '13 Toyota Tundra 90 day: 18.03 mpg (US) Thanks: 174 Thanked 60 Times in 56 Posts	HI, I am designing and rounding up parts to build an Electric, two seat, 4 wheel light Utility Vehicle. I'm going to use two motorcycles for the suspensions, and I want to start with the 48 volt Club Car motor I have ( I think, it's been so long since I saw it). I obviously need a shaft and bearing plate for the motor, if that is something you could make, I'd love to discuss it! I will probably direct mount it to a small differential with a flex coupling, so it doesn't need to take chain stress ( outer bearing). I have a thread on my project, it's at Fossil Fuel Free..."I want a Hybrid Side by Side". Hope to hear from you soon!