Quote:
Originally Posted by Yoshi
Have you checked the schematic shown at my post?
The S1 is actually the standard reset button connected to ground on the Arduino.
Yoshi
|
Thank you Yoshi. I did look at the schematic, but didnt notice that was the reset up there in the corner. For some reason I was thinking the circle where it said reset was the reset button, and I was thinking it needed to be connected to 5v thru a 10 resistor. Guess Ive been looking at too many tactile switches. Im not the best at reading schematics but Im learning.
That makes it a lot easier, only one more wire to run to my front button board.