Finally put the camber arms on a few nights ago and dialed out a lot of the camber. I'm still waiting on front strut camber/caster plates to dial out some of the camber, then going to adjust the toe to 1/8" total in on the front and .1/4" total in on the rear per specs. That's towards the low side for the rear.
Also going over to a buddies place that does signs/graphics to print out some wheel decals that I'm going to apply to the bottom of the pizza pans I have. I don't want just plain looking aluminum pizza pans over my wheels.
Pic of the wheels I used as a guide and sample for the pattern. My 'decals' are 20 spoke instead of the below which are 19... 20 divides into 360 a lot easier for patterning in Photoshop.
