View Single Post
Old 06-25-2017, 05:29 PM   #413 (permalink)
Bill the Engineer
Master EcoModder
 
Bill the Engineer's Avatar
 
Join Date: Dec 2013
Location: Lower Slower Delaware
Posts: 461
Thanks: 430
Thanked 866 Times in 348 Posts
Things are getting a bit topsy-turvy in the garage at the moment with all of the different equipment I am using. I get an extra long weekend next weekend to clean up though.



I am trying a new technique for the next pieces of metal to get welded in. I wasn't happy with the results I was getting from welding two pieces of sheet metal edge-on at a 90 degree angle (while nearly standing on my head at the same time to reach them.) These next pieces will have backing angles attached to bridge the gap where I am welding. I should have cleaner and faster results that way.




Bill the Engineer
  Reply With Quote
The Following User Says Thank You to Bill the Engineer For This Useful Post:
aerohead (06-19-2020)