|
Hey Paul, thanks for the super quick response!
I saw that list of color/signal pairs in the board documentation, but it didn't match mine (I think I have a 2011) :shrug:
Hmmm okay, I'm fairly confident I have the ex/!ex pair right (discounting polarity), so it shouldn't take more than a few tries (8 possible combinations). I've crimped the connector leads onto my wires, but luckily I haven't stuffed them into the connector housing yet. I think I'll try alligator clips until I get a working setup.
And this might sound like a dumb question, but where does the resolver's GND wire go to? There are two more wires coming from the motor that I think are for a temp sensor, surely it's not one of those?
|