View Single Post
Old 04-23-2020, 09:52 AM   #104 (permalink)
Master EcoModder
teoman's Avatar
Join Date: Jan 2017
Location: Istanbul
Posts: 1,245

A3 - '12 Audi A3
Thanks: 65
Thanked 225 Times in 186 Posts
What i did once with 3d printed cases is create stubs for the holes, and press/mushroom them with a soldering iron to attach the boards in place (after putting the board on).

I did this when I printed parts for my students and did not want to waste time and bolts for parts that I was going to give away.

It will make removing the parts more difficult, but you do not have to deal with bolts and tapping and nuts.

Last edited by teoman; 04-23-2020 at 10:43 AM..
  Reply With Quote
The Following 2 Users Say Thank You to teoman For This Useful Post:
Daox (04-23-2020), MetroMPG (05-01-2020)