|
The few times I had to level the bed of a 3d printer I just set the z height using a piece of paper as the feeler gage. Then went around to the 4 corners going clockwise and did a test print. Then based on the thickness (or how smashed) the layer was on the sides I adjusted from there until it looked consistent. So far no I haven't had any problems.
__________________
1973 Fiat 124 Special
1975 Honda Civic CVCC 4spd
1981 Kawasaki KZ750E
1981 Kawasaki KZ650 CSR
1983 Kawasaki KZ1100-A3
1986 Nissan 300zx Turbo 5 spd
1995 Chevy Astro RWD (current project)
1995 Mercury Tracer
2017 Kawasaki VersysX 300
2022 Corolla Hatchback 6MT
https://www.youtube.com/channel/UC6s...LulDUQ8HMj5VKA
|