Toyota Echo 2005 Base Model with unknown mileage. 1NZ-FE 1.5L Engine & C150 5 Speed Transmission. The body is in great condition but the mechanic is ****. Basically just a clean new shell to swap over the parts from my previous Echo which was begining to rust at very dangerous places.
This one is a base model so it doesn't have electric door locks and also didn't come with A/C which is a bonus since its lighter and I don't have to delete those.
It is now swapped with Echo-Francis rebuilt 1NZ-FE with FXE Prius Pistons
Next project is to swap it to a Xrs 2ZZ-GE + C60 in the near future
Build Thread:
Current Mods:
-Echo RS Cluster With Tachometer
-NRG Prisma Ultra Race Bucket Seat (Driver)
-Echo RS Seat (Passenger)
-Matrix Xrs Steering Wheel
-Rebuilt 1NZ-FE with FXE Prius Pistons (13:1 CR)
-Vented Valve Cover (PCV Valve Delete)
-NGK Irridium Sparkplugs
-NGK Ignition Coils
-Weapon R Intake Manifold
-Weapon R 4-2-1 Header
-Scion xB C50 Transmission (4.3 FD) With Tercel C151 Fifth Gear Swap
-Cosmo Racing Short Shifter With Solid Aluminium Base Bushings
-Aluminium Shift Knob
-MWR Solid Brass Shifter Cables Bushings
-Fidanza Lightweight Aluminium Flywheel
-Celica GT-S (2ZZ-GE) Exedy Stage 1 Clutch And Pressure Plate
-NST Lightweight Aluminium Crank Pulley
-Custom 2'' Exhaust With No Cat, Resonator + Magnaflow Muffler and DC Sports Tip
-DIY Polyeurethane Filled Engine and Tranny Mounts
-Rebuilt Subframe With Reinforced Control Arms + Siberian Bushings and Moog Balljoints
-Sway Bar with Siberian Bushings and Moog Link Kit
-Manual Steering Rack Conversion With Siberian Bushings And Moog Tie Rods and Tie Rod Ends
-Godspeed Mono SS Full Adjustable Coilovers
-Megan Racing Strut Bar
-NSK Wheel Bearings And New Axles
-Bremsen Rotors With Wagner Ceramic Brake Pads
-Raybestos Drums, Shoes And Wheel Cylinder
-Timken Rear Wheel Bearings
-2000 Echo Stock ECU
-DRL Delete
-LED Lights
-Lightweight 14'' Mags with Nokian Germain Winter Tires
-Weight Remove
-Radio and Speakers Delete
-Engine Block Heater
-Polished Throttle Body And IACV Cleaned
-Modified Intake To Fit a Pod Filter with stock MAF Housing
-Spectra Premium Radiator With Gates Hoses
-78°C Motorad Thermostat
-1.3 Bar TRD Radiator Cap
-AEM Air/Fuel Ratio Gauge and Sensor
-Secondary 02 Sensor Spacer (Cat Delete)
-Digital Voltmeter
-Honda Insight ZE1 Spare Tire
-Kosei K1-TS 14X6 Ultra Lightweight Race Wheels
Planned Mods:
-Racing Wheels & Tires (15'')
-Performance Big Brakes (255mm to 275mm Rotors)
-More Weight Remove
-Battery Relocation
-Custom Cold Air Intake
-Reflash ECU
-2ZZ-GE + C60 Swap
-Custom 3'' Exhaust No Cat, Resonator + Muffler Stainless Steel TIG Welded With Pie Cuts and Vbands
-Oil Catch Can
-Oil Cooler
-Adjustable Fuel Pressure Regulator
-AEM or Walbro 255 Fuel Pump
-ARP Extended Wheel Studs
-Race Lug Nuts
