Go Back   EcoModder Forum > Search Forums
Reload this Page Search Results
Register Now
 Register Now
 

Showing results 1 to 9 of 9
Search took 0.00 seconds. Search: Posts Made By: hardline
Forum: EcoModding Central 10-21-2015, 11:10 AM
Replies: 422
Views: 105,632
Posted By hardline
I'd be very careful about changing the...

I'd be very careful about changing the transmission out. The ECM has a turbine input speed sensor and the differential speed sensor. If they don't match, it will freak out, declare the gear ratios...
Forum: EcoModding Central 10-02-2015, 09:29 AM
Replies: 422
Views: 105,632
Posted By hardline
That turbo would be ideal for a daily driver that...

That turbo would be ideal for a daily driver that size, not sure though on trying to squeeze mileage out of it. A .64 a/r turbine housing is fairly restrictive.
Forum: EcoModding Central 10-01-2015, 01:35 PM
Replies: 422
Views: 105,632
Posted By hardline
Havent topped 2500 RPM in months? I should take...

Havent topped 2500 RPM in months? I should take you for a drive in my ZX2. 8200 RPM redline, yessir.
Forum: EcoModding Central 09-30-2015, 09:00 AM
Replies: 422
Views: 105,632
Posted By hardline
There are some variable vane turbos in the GT22...

There are some variable vane turbos in the GT22 size range that are used on TDI cars. That might work great for you as well.
Forum: EcoModding Central 09-29-2015, 05:47 PM
Replies: 422
Views: 105,632
Posted By hardline
You need a certain amount of airflow to spool the...

You need a certain amount of airflow to spool the turbine. VGT only goes so far in regards to that. The VGT turbo would be an interesting choice with the 2.0 setup, but the 1.0 just doesnt put...
Forum: EcoModding Central 09-29-2015, 04:40 PM
Replies: 422
Views: 105,632
Posted By hardline
The GT35R has a decent efficiency island in the...

The GT35R has a decent efficiency island in the lower pressure ratio region, The turbo I use, while it may "work", it is not operating anywhere close to it's peak thermal efficiency, and is...
Forum: EcoModding Central 09-29-2015, 04:32 PM
Replies: 422
Views: 105,632
Posted By hardline
Start pouring over compressor maps and find what...

Start pouring over compressor maps and find what best fits your needs
Forum: EcoModding Central 09-29-2015, 11:30 AM
Replies: 422
Views: 105,632
Posted By hardline
I think that turbo is too big. I am using a...

I think that turbo is too big. I am using a GTX2863R and I don't start to even see boost until 2000 RPM, and fully spooled by 3600 RPM, but then again I am running much higher pressures, and for a...
Forum: EcoModding Central 09-27-2015, 03:36 AM
Replies: 422
Views: 105,632
Posted By hardline
Since I see that the conversation has moved over...

Since I see that the conversation has moved over here, Hi.

I would not run just one intake per cylinder, as you will have a ton of fuel pool up on the disabled intake valve in the bowl area. It...
Showing results 1 to 9 of 9

 
Forum Jump

Contact Us - EcoModder.com - Archive - Recent Posts - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com