EcoModder.com - Search Results

Glossary

		EcoModder Forum > Search Forums
Search Results

Showing results 1 to 5 of 5
Search took 0.01 seconds. Search: Posts Made By: amino

Forum: Open ReVolt: open source DC motor controller

06-16-2013, 01:21 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,412,164

Posted By amino

I had a similar experience as duncan when testing...

I had a similar experience as duncan when testing my car with a smaller battery pack than normal. It turned out to be the DC to DC converter, which would cut out when the voltage sagged below 75...

Forum: Open ReVolt: open source DC motor controller

12-15-2011, 12:41 AM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,412,164

Posted By amino

Paul, at the risk of breaking Rule #1 : Blame...

Paul, at the risk of breaking Rule #1 : Blame someone else when it doesn't work, I think it was probably something I probably did in the process of looking for the cause of the initial malfunction. ...

Forum: Open ReVolt: open source DC motor controller

12-14-2011, 06:31 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,412,164

Posted By amino

I picked up an optocoupler from the nearby...

I picked up an optocoupler from the nearby supplier, soldered it in, powered up the controller, and as the precharge time expired, the contactor clicked closed! It was working again! However the...

Forum: Open ReVolt: open source DC motor controller

11-30-2011, 07:19 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,412,164

Posted By amino

I drove the car for the first time since...

I drove the car for the first time since installing the Open Revolt/Cougar controller, and it runs beautifully! Smooth starts, great acceleration and power to spare. I had used most of the settings...

Forum: Open ReVolt: open source DC motor controller

11-29-2011, 09:34 PM

Replies: 7,381

Sticky: Paul & Sabrina's cheap DIY 144v motor controller

Views: 2,412,164

Posted By amino

I had the rear connector cover panel from a 37"...

I had the rear connector cover panel from a 37" ViewSonic TV which happened to be about the same height, so I cut a piece from each end the width of the case and filed the edges to fit. Since it is a...

Showing results 1 to 5 of 5

Forum Jump