Forum: EcoModding Central
07-19-2011, 12:39 AM
|
Replies: 3
Views: 3,405
From talking an electric motor engineer a while...
From talking an electric motor engineer a while back it sounded like a 48v motor work work at higher voltage as long as it's a series wound motor, it will run hotter so forced cooling will be needed...
|
Forum: EcoModding Central
07-18-2011, 10:07 PM
|
Replies: 3
Views: 3,405
Try the ev forums. There are articles too.
...
Try the ev forums. There are articles too.
DIY Electric Car Forums - Electric Vehicle Build and Conversion Community (http://www.diyelectriccar.com/forums/)
Just don't leave us forever.
|
Forum: DIY / How-to
03-30-2010, 06:25 AM
|
Replies: 344
Views: 82,809
I made a 1/24th scale (aka 1/2" = 1'-0") wooden...
I made a 1/24th scale (aka 1/2" = 1'-0") wooden model first, and then traced photos of it in DataCAD. Then I did orthographic projection from 5 views to make 15 section profiles; separated by 1 foot...
|
Forum: Open ReVolt: open source DC motor controller
04-29-2009, 01:31 AM
|
Replies: 7,381
Views: 2,411,832
|