Go Back   EcoModder Forum > EcoModding > General Efficiency Discussion
Register Now
 Register Now
 

Reply  Post New Thread
 
Submit Tools LinkBack Thread Tools
Old 11-25-2008, 11:22 AM   #1 (permalink)
EcoModding Lurker
 
Join Date: Nov 2008
Location: Toronto, ON
Posts: 13

Dexter - '91 BMW 318i
90 day: 27.09 mpg (US)

Padmé - '06 Mazda MX-5 Miata
90 day: 27.53 mpg (US)
Thanks: 0
Thanked 0 Times in 0 Posts
Does elevation above/below sea level have any bearing on FE?

Quick proviso: Of my two cars, I drive one for mileage, one for fun. This post concerns the fun car

Last summer, I took a long road trip through the southwestern states. At no point was I driving for FE, but there were some portions where topography and traffic conditions lent themselves to fuel efficiency. During these situations, I averaged around 33 mpg.

I drove extremely quickly through Death Valley, enjoying every drop of performance the car had to offer. Filling up in Pahrump, Nevada, I logged my best tank of the trip: 34.7 mpg.

Could Death Valley's below-sea-level (-200 feet) elevation have anything to do with this FE result? I usually average in the 26-to-28 range during spirited driving mixed with highway. It seems incredible that I could run for extended periods at high RPM and still achieve nearly 35 mpg.

For reference, I was driving a 2006 Mazda MX-5 Miata 6MT.

TIA for your thoughts!

__________________

  Reply With Quote
Alt Today
Popular topics

Other popular topics in this forum...

   
Old 11-25-2008, 12:12 PM   #2 (permalink)
EcoModding Apprentice
 
dichotomous's Avatar
 
Join Date: Nov 2008
Location: vermont
Posts: 142

CivySi - '03 honda civic SI
90 day: 31.99 mpg (US)
Thanks: 0
Thanked 1 Time in 1 Post
I think it was the excessive heat that helped your fuel economy there. and hurt your performance, you would have gone faster almost anywhere else.
__________________
  Reply With Quote
Old 11-25-2008, 12:28 PM   #3 (permalink)
Master EcoModder
 
Join Date: Jun 2008
Location: Earth
Posts: 5,209
Thanks: 225
Thanked 811 Times in 594 Posts
My experience has been just the opposite: I get better mpg around home (elevations from 4500 to 8900 ft) than I do in the near sea level areas around the Bay Area.
  Reply With Quote
Old 11-25-2008, 12:35 PM   #4 (permalink)
Master EcoModder
 
NeilBlanchard's Avatar
 
Join Date: May 2008
Location: Maynard, MA Eaarth
Posts: 7,907

Mica Blue - '05 Scion xA RS 2.0
Team Toyota
90 day: 42.48 mpg (US)

Forest - '15 Nissan Leaf S
Team Nissan
90 day: 156.46 mpg (US)

Number 7 - '15 VW e-Golf SEL
TEAM VW AUDI Group
90 day: 155.81 mpg (US)
Thanks: 3,475
Thanked 2,950 Times in 1,844 Posts
Hello,

It depends a lot on whether the vehicle has a carburetor or fuel injection.
__________________
Sincerely, Neil

http://neilblanchard.blogspot.com/
  Reply With Quote
Old 11-25-2008, 01:05 PM   #5 (permalink)
Master EcoModder
 
basjoos's Avatar
 
Join Date: Dec 2007
Location: Upstate SC
Posts: 1,088

Aerocivic - '92 Honda Civic CX
Last 3: 70.54 mpg (US)

AerocivicLB - '92 Honda Civic CX
Team Honda
90 day: 55.14 mpg (US)

Camryglide - '20 Toyota Camry hybrid LE
90 day: 62.77 mpg (US)
Thanks: 16
Thanked 676 Times in 302 Posts
Your good mileage running through Death Valley was the result of the high air temps. The hotter the air, the thinner it is. I live at 1000 feet elevation. To get the same air density that they have at 10,000 feet elevation, the temperature around here would have to get up to 170 degrees F. If you know the air temperature and humidity during your drive through Death Valley, you could look them up in a density altitude chart to see what your air pressure altitude was.

You get better mileage at higher elevations because the air is thinner, which reduces your aerodynamic drag. Also the thinner air reduces the power output of normally aspirated engines and you have to operate at higher throttle settings with reduced pumping losses to get the same power output. Also modern engines automatically reduce the amount of fuel that they use since there is less oxygen in the thinner intake air to mix with the fuel. With older carburated cars you had to adjust the mixture as you went up in elevation to get them to run efficiently, otherwise they would run richer and richer as you climbed into thinner air. Then you had to remember to adjust the mixture back as you descended, otherwise the mixture would get too lean and the engine would become gutless when you floored the accelerator and also risked burning the valves.
__________________
aerocivic.com
  Reply With Quote
Old 11-25-2008, 01:33 PM   #6 (permalink)
EcoModding Lurker
 
Join Date: Nov 2008
Location: Toronto, ON
Posts: 13

Dexter - '91 BMW 318i
90 day: 27.09 mpg (US)

Padmé - '06 Mazda MX-5 Miata
90 day: 27.53 mpg (US)
Thanks: 0
Thanked 0 Times in 0 Posts
Very interesting -- Historical weather data indicates that temperatures reached 109°F on the day I passed through. That's quite fascinating.

Thanks for the quick and concise explanation!
__________________

  Reply With Quote
Old 11-25-2008, 09:17 PM   #7 (permalink)
Master EcoModder
 
Big Dave's Avatar
 
Join Date: Jan 2008
Location: Steppes of Central Indiana
Posts: 1,319

The Red Baron - '00 Ford F-350 XLT
90 day: 27.99 mpg (US)

Impala Phase Zero - '96 Chevrolet Impala SS
90 day: 21.03 mpg (US)
Thanks: 0
Thanked 186 Times in 127 Posts
The high temperature reduced the air density and that reduced your aero drag.
__________________
2000 Ford F-350 SC 4x2 6 Speed Manual
4" Slam
3.08:1 gears and Gear Vendor Overdrive
Rubber Conveyor Belt Air Dam
  Reply With Quote
Old 11-27-2008, 06:46 PM   #8 (permalink)
Renaissance Man
 
Formula413's Avatar
 
Join Date: Jan 2008
Location: In the Northeast dreaming of the Southwest
Posts: 596

Aegean C - '17 Honda Civic LX
90 day: 38.89 mpg (US)
Thanks: 20
Thanked 31 Times in 24 Posts
Quote:
Originally Posted by basjoos View Post
You get better mileage at higher elevations because the air is thinner, which reduces your aerodynamic drag. Also the thinner air reduces the power output of normally aspirated engines and you have to operate at higher throttle settings with reduced pumping losses to get the same power output.
Bingo. Hot air = higher density altitude. So due to the heat your low altitude was actually providing the FE benefits of higher altitude.
__________________

  Reply With Quote
Old 11-28-2008, 06:47 PM   #9 (permalink)
Master EcoModder
 
Join Date: Jan 2008
Location: Victoria , Australia.
Posts: 499
Thanks: 20
Thanked 46 Times in 33 Posts
A couple of very quick rules of thumb to help out are below.

For every 1 , 000 ft elevation deduct about 3% power.
For very 7 degree C increase in ambient temperature deduct about 1% power.

Not hard and fast but reasonably accurate none the less.

Cheers , Pete.

  Reply With Quote
Reply  Post New Thread


Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Basic EcoDriving Techniques and Instrumentation SVOboy Instrumentation 2 11-17-2007 11:38 AM



Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com