Difference between revisions of "Increased compression ratio"
(Created page with "Back to main mod page Image:CompressionRatio.jpg '''Introduction'''...") |
(No difference)
|
Latest revision as of 16:44, 8 July 2018
Introduction
Increasing compression increases the efficiency of an engine with all else being equal. However, this requires a head gasket swap, head shaving, block shaving, or new pistons. It's an involved process, but if you have the engine apart already its worth looking into.
Contents
Instructions for mod
How increase compression
Increase engine displacement. By boring or sleeving the block, or stroking the engine (increasing distance of the piston stroke).
Decreasing combustion chamber volume. Changing cylinder heads to ones that have a smaller combustion chamber, Switching to pistons that are flat or slightly domed. This is the most effective way to increase compression ratio.
Information required: A listing for different ways to do this if its different on different types of cars
User experiences
Increasing compression by a full number normally results in up to a 1.4% increase in engine efficiency.
| User Name | Car Make, Model, Year | Cost of Mod | Time to Perform Mod | MPG Before Mod | MPG After Mod | MPG improvement guess | Instruction Link |
|---|---|---|---|---|---|---|---|
| Example Data Saand | Example Data Mazda, 626, 1991 | Example Data $5 USD | Example Data 1 Hour | Example Data 27.2 | Example Data 29.8 | User mod detail or measurement detailed data |
You can figure how much pressure your engine will develope on the compression stroke with a simple formulia. p = PxCR^r (pressure times compression ratio to the power of 1.4)
p = compression pressure
P = 1 atmosphere in most cases
CR = compression ratio number
r = specific heat ratio for working fluid, for air this is 7/5 or 1.4
Problems / Consequences of mod
Increasing compression can lead to knock with lower grade gas and may require a higher octane to prevent this.
Information required: What are the consequences of the mod, Eg: drivability issue, stalling, engine wear,
