Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Paul & Sabrina's cheap DIY 144v motor controller

sawickm · 10-15-2009, 02:07 PM

What is the latest revision being used for the controller

I noticed that “Mcudogs” posted a revision D Controller & Power PCB schematic on 09/10/09. It was not added into the Wiki ??? and I don’t think the Wiki software supports it ???

FYI: I don’t know if this was pointed out yet, but looking over the revision D schematic I noticed that the symbols for U13 & U14 (PC900V0NSZXF) pins 4 & 5 are backwards. Pin 5 should be GND, and Pin 4 should be V0 (see attachment). They are used for the new A/D input and Battery Voltage Monitor circuits.

Click image for larger version

Name: pc900v0nszx.jpg
Views: 85
Size: 112.5 KB
ID: 4456

-Mark

10-15-2009, 02:07 PM	#2426 (permalink)
sawickm ReVolt Enthusiast Join Date: Jun 2009 Location: Michigan, USA Posts: 239 Thanks: 98 Thanked 47 Times in 40 Posts	Revision D Controller ??? What is the latest revision being used for the controller I noticed that “Mcudogs” posted a revision D Controller & Power PCB schematic on 09/10/09. It was not added into the Wiki ??? and I don’t think the Wiki software supports it ??? FYI: I don’t know if this was pointed out yet, but looking over the revision D schematic I noticed that the symbols for U13 & U14 (PC900V0NSZXF) pins 4 & 5 are backwards. Pin 5 should be GND, and Pin 4 should be V0 (see attachment). They are used for the new A/D input and Battery Voltage Monitor circuits. -Mark