|
Vacuum Gauge Install; Engine Line Tap Location
I picked up the Auto Meter Vacuum Gauge (2610). I was going to tap into the vacuum line between the PCV valve and the manifold. Is this a good location? Or is there a better line to tap into?
The gauge came with a VERY small tee and I would have to purchase a larger one in order to use the PCV valve line.
Any suggestions would be very helpful!!
Thanks.
ZO.
__________________
Quote:
Originally Posted by cRiPpLe_rOoStEr
Big Oil hates lean-burn.
|
Quote:
Originally Posted by cowmeat
If my hypermiling in the Insight cancels out the effects of just one gap toothed git-er-done in his big dumb F250 dually with his inbred kids and pitbull hanging off the side rails in the back, glaring at me as they roll coal around me . . . . . then maybe there will be some gas left when my grand kids start to drive.
|
|