Fuel Economy, Hypermiling, EcoModding News and Forum - EcoModder.com - View Single Post - Hot-rodding the Toyota MGR

e*clipse · 08-31-2014, 03:59 AM

Here are some of the guts. I'm breaking the posts up to make discussion easier.

I'll start with the stator. It's part of the middle section of the assembly.

Here's a closup of the stator slots and windings. There are 48 slots. The stator OD is 235mm, and the ID is 150mm. The slot width is 45mm.

Here's a closup showing some of the winding details. The winding wire diameter (including varnish) is 0.030", close to AWG #21. There are three wire groups/phase; I think there are 12 wires/phase.

08-31-2014, 03:59 AM	#12 (permalink)
e*clipse Permanent Apprentice Join Date: Jul 2010 Location: norcal oosae Posts: 523 Thanks: 351 Thanked 314 Times in 215 Posts	Here are some of the guts. I'm breaking the posts up to make discussion easier. I'll start with the stator. It's part of the middle section of the assembly. Here's a closup of the stator slots and windings. There are 48 slots. The stator OD is 235mm, and the ID is 150mm. The slot width is 45mm. Here's a closup showing some of the winding details. The winding wire diameter (including varnish) is 0.030", close to AWG #21. There are three wire groups/phase; I think there are 12 wires/phase.