Quote:
|
You don’t think a small gap, I.E. 1/4”-3/8” would cause the same problem?
|
I watched aerohead tape the gap on his T-100's bed gap at the Darko wind tunnel so he would have hard data. [citation needed]
One might finesse the edge so that the gap isn't on a flat plane, but at the bottom of a shallow crease. Don't know about that. 120° instead of 180° should suffice.
A pickup bed aerocap would be a good model to follow. Examples vary. But they exhibit how to add plan taper. See also the 'bubble-top coupe'.
__________________
.
.Without freedom of speech we wouldn't know who all the idiots are. -- anonymous poster
________________
.
.Because much of what is in the published literature is nonsense,
and much of what isn’t nonsense is not in the scientific literature.
-- Sabine Hossenfelder
Last edited by freebeard; 01-07-2022 at 02:16 PM..
|