Go Back   EcoModder Forum > EcoModding > EcoModding Central
Register Now
 Register Now
 

Reply  Post New Thread
 
Submit Tools LinkBack Thread Tools
Old 02-01-2012, 03:54 AM   #1 (permalink)
Lead-footed Econewbie
 
Join Date: Apr 2009
Location: Wellington, New Zealand
Posts: 52

Ceffy - '97 Nissan Cefiro 25 excimo
90 day: 25.21 mpg (US)

Demio - '07 Mazda Demio Sport
90 day: 30.99 mpg (US)
Thanks: 4
Thanked 5 Times in 2 Posts
Fiddling with a variable manifold - locking it in high rpm mode

My car has a variable intake manifold, that switches between a long runner'd intake with a low volume plenum, over to short runners and a reasonably large resonance chamber positioned about half way along the intake runners. This kicks in about 5500rpm and fills in a torque hole from there to the redline. Actually has quite a strong effect, takes the 2.5L engine from about 165hp @5600 to 190 @ 6500. But below 5000 rpm it hurts torque.

Now I wonder if locking this open in it's high-rpm mode would provide some low-rpm efficiency gains. Mainly by allowing the throttle to be wider open. It noticeably dulls response at low speed, need put foot down further to get the car going. Am I on to something here or would the two effects cancel each other out? Being an automatic I'm probably inviting more kick-down but I can mitigate that by putting transmission in snow mode - really resists kick-down then.

(Car is a 97 Nissan Cefiro imported to NZ from Japanese domestic market, has the variable plenum not fitted to the almost identical 4th gen US Maxima, the Japan and Middle East version had a variable intake for a kick of top end power - jokingly known as MEVI for Middle Eastern Variable Intake).

Only other mod I have on the engine at the moment is a WAI and grill blocks. It'll be a while before I can test any effects it properly, but thought I put the idea out there for now.

  Reply With Quote
Alt Today
Popular topics

Other popular topics in this forum...

   
Old 02-01-2012, 07:51 AM   #2 (permalink)
Administrator
 
Daox's Avatar
 
Join Date: Dec 2007
Location: Germantown, WI
Posts: 11,203

CM400E - '81 Honda CM400E
90 day: 51.49 mpg (US)

Daox's Grey Prius - '04 Toyota Prius
Team Toyota
90 day: 49.53 mpg (US)

Daox's Insight - '00 Honda Insight
90 day: 64.33 mpg (US)

Swarthy - '14 Mitsubishi Mirage DE
Mitsubishi
90 day: 56.69 mpg (US)

Daox's Volt - '13 Chevrolet Volt
Thanks: 2,501
Thanked 2,585 Times in 1,553 Posts
Reducing maximum output at lower rpms to reduce pumping losses. IMO its worth a shot and I'd love to see some good testing done to see the results.
__________________
Current project: A better alternator delete
  Reply With Quote
Old 02-01-2012, 09:22 AM   #3 (permalink)
Eco-ventor
 
jakobnev's Avatar
 
Join Date: Oct 2010
Location: sweden
Posts: 1,630

Princess - '92 Mazda MX-3 GS
House of Tudor
Team Mazda
90 day: 53.54 mpg (US)

Shirubāarō (*´ω`*) - '05 Toyota Prius Executive
Team Toyota
90 day: 54.88 mpg (US)

Blue Thunder - '20 Hyundai IONIQ Trend PHEV
Team Hyundai
Plug-in Hybrids
90 day: 587.16 mpg (US)
Thanks: 74
Thanked 701 Times in 444 Posts
Send a message via MSN to jakobnev
(Assuming it works)

If instead of just locking it in high-rpm mode you make it so that it is in hight-rpm mode on low loads, and whatever mode is appropriate at hight loads, that way you don't lose any potential performance.
__________________




2016: 128.75L for 1875.00km => 6.87L/100km (34.3MPG US)
2017: 209.14L for 4244.00km => 4.93L/100km (47.7MPG US)
  Reply With Quote
Old 02-01-2012, 11:06 AM   #4 (permalink)
Master EcoModder
 
Join Date: Dec 2011
Location: Boise Idaho
Posts: 842
Thanks: 39
Thanked 89 Times in 69 Posts
nice thought, but it won't work. the runners "supercharge" the engine at certain RPM's, making the engine feel peppy and giving it that punch which makes people happy.

The AVERAGE vacuum level in the engine won't change, and the pumping losses from the throttle are related to the AVERAGE vacuum.

Really interesting thought though!
  Reply With Quote
Old 02-01-2012, 06:20 PM   #5 (permalink)
Eco-ventor
 
jakobnev's Avatar
 
Join Date: Oct 2010
Location: sweden
Posts: 1,630

Princess - '92 Mazda MX-3 GS
House of Tudor
Team Mazda
90 day: 53.54 mpg (US)

Shirubāarō (*´ω`*) - '05 Toyota Prius Executive
Team Toyota
90 day: 54.88 mpg (US)

Blue Thunder - '20 Hyundai IONIQ Trend PHEV
Team Hyundai
Plug-in Hybrids
90 day: 587.16 mpg (US)
Thanks: 74
Thanked 701 Times in 444 Posts
Send a message via MSN to jakobnev
Quote:
The AVERAGE vacuum level in the engine won't change, and the pumping losses from the throttle are related to the AVERAGE vacuum.
I believe this to be incorrect. A pressure wave that arrives too early during the intake stroke, will increase the mean pressure without increasing the final pressure in the cylinder. And that will decrease the pumping loss without increasing engine load.
__________________




2016: 128.75L for 1875.00km => 6.87L/100km (34.3MPG US)
2017: 209.14L for 4244.00km => 4.93L/100km (47.7MPG US)
  Reply With Quote
Old 02-01-2012, 06:41 PM   #6 (permalink)
MPGuino Supporter
 
t vago's Avatar
 
Join Date: Oct 2010
Location: Hungary
Posts: 1,807

iNXS - '10 Opel Zafira 111 Anniversary

Suzi - '02 Suzuki Swift GL
Thanks: 828
Thanked 708 Times in 456 Posts
Only way to know for sure is to get a dyno chart of this engine's output, both with and without tuning valve engagement.

I did something like this when I retrofitted a tuning valve onto my intake manifold about 9 years ago:



The blue line was with the tuning valve in the open (off) position, and the red line was with the tuning valve in the shut (active) position.
  Reply With Quote
The Following User Says Thank You to t vago For This Useful Post:
Ryland (02-01-2012)
Old 02-02-2012, 03:44 AM   #7 (permalink)
Lead-footed Econewbie
 
Join Date: Apr 2009
Location: Wellington, New Zealand
Posts: 52

Ceffy - '97 Nissan Cefiro 25 excimo
90 day: 25.21 mpg (US)

Demio - '07 Mazda Demio Sport
90 day: 30.99 mpg (US)
Thanks: 4
Thanked 5 Times in 2 Posts
Interesting. On my next tank I might test it in the full time open position. I have a pretty regular commute with a few steep hills and will at least be able to tell if I'm holding a more open throttle position for the speed I usually climb at.
  Reply With Quote
Old 02-02-2012, 07:40 AM   #8 (permalink)
EcoModding Lurker
 
Join Date: Jan 2010
Location: Wi.
Posts: 75
Thanks: 0
Thanked 4 Times in 4 Posts
Long runners help build low end torque, this is good for mpg, esp. if the gearing is matched.
  Reply With Quote
Old 02-02-2012, 06:20 PM   #9 (permalink)
Master EcoModder
 
Join Date: Aug 2010
Location: Philippines
Posts: 2,173
Thanks: 1,739
Thanked 589 Times in 401 Posts
Having an engine with the same system, no, it won't work.

We've done street tests and dynos, and with the short runners open at low rpms, you lose a whole lot of power.

The runners don't just provide volume, the tuning of the long runners is optimized for torque. Shortcutting that will lose you said torque.

What you may want is to hook something like an aftermarket "VTEC solenoid", which allows you to select the activation rpm for the secondary runners. Set it a bit lower (maybe 4000 rpm), but not too low. Dyno data for your specific engine should tell you where the runners always open and runners always closed graphs intersect, and where it would be most useful to open them.
  Reply With Quote
Old 02-02-2012, 06:34 PM   #10 (permalink)
Administrator
 
Daox's Avatar
 
Join Date: Dec 2007
Location: Germantown, WI
Posts: 11,203

CM400E - '81 Honda CM400E
90 day: 51.49 mpg (US)

Daox's Grey Prius - '04 Toyota Prius
Team Toyota
90 day: 49.53 mpg (US)

Daox's Insight - '00 Honda Insight
90 day: 64.33 mpg (US)

Swarthy - '14 Mitsubishi Mirage DE
Mitsubishi
90 day: 56.69 mpg (US)

Daox's Volt - '13 Chevrolet Volt
Thanks: 2,501
Thanked 2,585 Times in 1,553 Posts
The point of it is to loose torque at low rpms. This allows you to open the throttle for the same power output and reduce pumping losses which should increase engine efficiency.

__________________
Current project: A better alternator delete
  Reply With Quote
Reply  Post New Thread


Thread Tools




Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com