This is really interesting. Good luck, hey. But what about the torque measurement problem? You can control the sources of error jakobnev describes?
Quote:
Originally Posted by SentraSE-R
Back to the drawing board. I'll need to daisy chain my UG to my SG to see LOD. The SG in Performance Mode shows distance, speed, and time. It leaves no way to display LOD.
When you save a performance run, it only saves distance, speed, and time. I saved four pulses, and found none of my LHK values were recoverable. So I could only make one run, then had to copy the data before the next run. I'll post some data/graphs tomorrow, after I plot the data and make some graphs.
|