|
Skip Plate Update
Ok had some more time to work on the skid plate. Turns out my 2000 pound epoxy doesn't want to stick to the galvanized steel. So I switched to using pop rivets instead. Got the two peices connected together (needed 37" the sheet was only 36". Grr) and all of the cutting and bending done. I plan on putting in a few more pop rivets along the bottom edge to strengthen the panel up a little bit more (plus I like the looks of them). Then about all thats left is the final mounting.
__________________
Adjusted for my driving habits. 80%city/20%Highway.
20mpg city/30mpg highway or bust! Check out my mods so far
|