1993 Civic VX drivetrain & parts

[tim3058]

Asking prices reduced - open to offers as well....

Hey guys I have had a bunch of parts sitting in my garage since I scrapped the Civic. Have gone another route now, haven't used this stuff yet so maybe some of you can.

D15Z1 VTEC-E motor, had the head shaved .010", 3-angle valve job, new gaskets, timing set, underdrive crank pulley, alternator, O2, includes intake, TB, distr, VX ECM, etc, as pulled from car. Has the P20 5-spd trans out of a CX (same as VX), with the tall gear ratios. New clutch, flywheel machined, throwout bearing and slave cylinder replaced. No problems. I have at least one of the CV shafts with it. All work done in the last 25k. $550/all

Skunk2 upper control arms w/ adjustable cambers. $50

B&M fuel pressure gauge - $15

Exhaust, rusty 4-2-1 header with clean newer midpipe (from header to muffler). $30

I'd take any fair offers on any of above. Thanks guys.

[iceyinferno]

Location?

[AbramWagner]

Interested in wheels depending on location

[tim3058]

Originally Posted by AbramWagner

Interested in wheels depending on location

Would probably be nice to know where I am wouldn't it

I'm in central NY state.

I sent you a pm AbramWagner

[AbramWagner]

Any pictures of the rims and tires? More so the vx

[tim3058]

Motor & Transmission:
















Back of trans





Back side of block

[tak209]

would you sell the intake manifold, fuel rail, injectors,tb and sensors on manifold?

[tim3058]

Originally Posted by tak209

would you sell the intake manifold, fuel rail, injectors,tb and sensors on manifold?

Hi there, at this point I would like to see if anyone wants the whole setup for a total swap. If no one takes the engine/trans together I will consider piecing it out. Thanks!

[tak209]

ok thanks lmk. =)

[MrBrenzo]

Tim, I am in need of a new motor, is yours still available?