Go Back   EcoModder Forum > Search Forums
Reload this Page Search Results
Register Now
 Register Now
 

Page 1 of 15 1 2311 Last »
Showing results 1 to 25 of 372
Search took 0.10 seconds. Search: Posts Made By: pgfpro
Forum: Introductions 04-16-2024, 09:32 AM
Replies: 54
Views: 8,825
Posted By pgfpro
New ride height for aero. 34672

New ride height for aero.

34672
Forum: EcoModding Central 04-15-2024, 08:35 PM
Replies: 477
Views: 129,971
Posted By pgfpro
Thanks for the video much appreciated. What...

Thanks for the video much appreciated.

What he is describing is actually what I'm doing too. lol

It's not really too bad even at 35:1 A/F to pull out of the lean-burn hole in the map. What I...
Forum: EcoModding Central 01-30-2024, 10:15 AM
Replies: 12
Views: 1,285
Posted By pgfpro
Here is one of the turbine housings that cracked...

Here is one of the turbine housings that cracked that I was talking about. 34498
Forum: EcoModding Central 01-28-2024, 11:04 AM
Replies: 12
Views: 1,285
Posted By pgfpro
I run a manifold and turbo blanket on my Talon...

I run a manifold and turbo blanket on my Talon during the Summer and hot Fall and Spring days. I pull heat off the lower side of my Exhaust manifold to increase the IAT'S up to 250*F. for FE.

One...
Forum: EcoModding Central 12-24-2023, 09:43 AM
Replies: 477
Views: 129,971
Posted By pgfpro
Sorry I'm still really new to YouTube. I...

Sorry I'm still really new to YouTube. I purchased Artlist that has a ton of music and other sounds effects etc. The Music in this video is from Ace, called Gain Over.
Forum: EcoModding Central 12-23-2023, 08:09 PM
Replies: 477
Views: 129,971
Posted By pgfpro
https://www.youtube.com/watch?v=t1XqwS-R4os ...

https://www.youtube.com/watch?v=t1XqwS-R4os

My new video with actual testing the Passive Pre-Chamber. Also, it shows the data logs much better. ;)
Forum: EcoModding Central 12-19-2023, 10:10 AM
Replies: 477
Views: 129,971
Posted By pgfpro
After reading my post I realized that I didn't...

After reading my post I realized that I didn't post the reason behind all this.

What my goal is to make this a GCI engine at higher boost while running an A/F ratio of 14.7:1. I knew that my PC...
Forum: EcoModding Central 12-18-2023, 10:22 PM
Replies: 477
Views: 129,971
Posted By pgfpro
Sorry about the pics they start out great but...

Sorry about the pics they start out great but lose a lot of resolution when I post them.
Forum: EcoModding Central 12-18-2023, 08:26 PM
Replies: 477
Views: 129,971
Posted By pgfpro
EcoModder's, Sorry to bore everyone on here with...

EcoModder's, Sorry to bore everyone on here with these posts, but I'm using this forum to show my data/information to other people from different forums and social media. It's easier to direct them...
Forum: EcoModding Central 12-17-2023, 09:32 AM
Replies: 477
Views: 129,971
Posted By pgfpro
34430 34431 Spent this week going over...

34430

34431

Spent this week going over my nitrous system logs. I built my very own system with some unique differences from other nitrous systems that are out there. My system is a direct port...
Forum: EcoModding Central 11-11-2023, 12:31 PM
Replies: 477
Views: 129,971
Posted By pgfpro
Dean, Thanks so much for your post. Just...

Dean,

Thanks so much for your post. Just finished watching it and there is lots of great information in it. I'm going to take some of this info and apply it to my program. On my nitrous race...
Forum: EcoModding Central 10-14-2023, 08:11 PM
Replies: 477
Views: 129,971
Posted By pgfpro
Sorry guys it's been a while since my last post....

Sorry guys it's been a while since my last post. Work has been taking up most of my spare time. Can't wait to retire in a few years so all my spare time can go into finish building the Camaro.

I...
Forum: Aerodynamics 05-05-2023, 09:25 AM
Replies: 7
Views: 650
Posted By pgfpro
Thanks for all the help, guys. Here is a short...

Thanks for all the help, guys. Here is a short video I made of the car.

https://youtu.be/idj6gIMgaIM

As you can see the hood already has a vented spot at the end of the cowl. From what I have...
Forum: Aerodynamics 05-04-2023, 10:58 AM
Replies: 7
Views: 650
Posted By pgfpro
Need the aero guys on here help???

As some of you know I'm building a 71 Camaro dual purpose car for Racing and FE. My question is where is the best place to pick up air for the engine? I'm thinking the cowl area before the...
Forum: Introductions 03-02-2023, 10:09 AM
Replies: 54
Views: 8,825
Posted By pgfpro
Camaro is finally a roller

This is the FE ride height. The top of roof is 47" from the ground. lol

Starting on the cage now and installing the floor.
Forum: EcoModding Central 11-19-2022, 11:11 AM
Replies: 477
Views: 129,971
Posted By pgfpro
Some more video of the Pre-Chamber flame. ...

Some more video of the Pre-Chamber flame.

https://youtu.be/zKcLteOkpoc
Forum: EcoModding Central 11-06-2022, 08:40 PM
Replies: 477
Views: 129,971
Posted By pgfpro
Thanks' and please Subscribe and Like, much...

Thanks' and please Subscribe and Like, much appreciated.

The draw backs in today's world are you're not supposed to mess with factory emissions. Thanks for bringing up a key point I keep...
Forum: EcoModding Central 10-31-2022, 09:52 AM
Replies: 477
Views: 129,971
Posted By pgfpro
https://youtu.be/-2M1fkSksbQ Did a new...

https://youtu.be/-2M1fkSksbQ

Did a new YouTube video intro on my 71Camaro with my Pre-Chamber and lean burn. On the next video I'll talk about ecomodder and drop a link here. I also did some new...
Forum: Introductions 07-10-2022, 08:24 PM
Replies: 54
Views: 8,825
Posted By pgfpro
Got some much-needed time this weekend on the...

Got some much-needed time this weekend on the Camaro. 1st pic is race ride height. 2nd pic is for FE and daily driving. Trying to get the Cd around 0.210 Going add some of the "HRM SPL Camaro" ideas...
Forum: EcoModding Central 07-04-2022, 03:28 PM
Replies: 477
Views: 129,971
Posted By pgfpro
Pre-Chamber V3

Doing some high boost 35psi plus testing with the new V3 Pre-Chamber.
Forum: EcoModding Central 07-04-2022, 11:14 AM
Replies: 92
Views: 9,737
Posted By pgfpro
Great Input Everyone

1st pic. This is my Hot Air Intake Injection system.
2nd pic this is a pic of my type of intake looking at the ports where the hot air enters the intake port and is aimed straight at the fuel...
Forum: EcoModding Central 07-02-2022, 09:51 AM
Replies: 92
Views: 9,737
Posted By pgfpro
Great discussion guys, even though the chemistry...

Great discussion guys, even though the chemistry is over my head lol.

I wish I could post video on here, I guess I could do a YouTube video.

When I tested with a simple Coleman lantern...
Forum: DIY / How-to 06-24-2022, 06:38 PM
Replies: 143
Views: 11,497
Posted By pgfpro
Cool, turned out great.

Cool, turned out great.
Forum: EcoModding Central 06-22-2022, 10:29 AM
Replies: 18
Views: 1,227
Posted By pgfpro
Thoughts on the amount of fuel burnt and its efficiency?

I've been pondering this for some time now. IMHO I believe that 95% or more of the fuel during the power stroke is burnt. X amount of fuel has X amount of energy.

So on my engine 0.144 lbs/min...
Forum: DIY / How-to 06-22-2022, 09:31 AM
Replies: 143
Views: 11,497
Posted By pgfpro
I agree I think you have to watch out with...

I agree I think you have to watch out with aftermarket O2's sensors. I have a fake BOSCH WB that reads 14.7 all the time.

Also I'll add on my setup I run in open loop all the time for fuel...
Showing results 1 to 25 of 372
Page 1 of 15 1 2311 Last »

 
Forum Jump

Contact Us - EcoModder.com - Archive - Recent Posts - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Content Relevant URLs by vBSEO 3.5.2
All content copyright EcoModder.com