Mpguino built, registering VSS when the wire is not hooked to anything

[dwills898]

I just built my mpguino and it looks like it is working but it is registering VSS and I think the Injector signal when their respective wires arent hooked to anything. Anybody have any suggestions, I have no experience with this stuff. Thanks

[dwills898]

I just cut the 2 sensor wires shorter and now its not doing it anymore. Was it just radio interference or something?

[Ecky]

Maybe, the MPGuino is highly sensitive. Touching the ends of the wires on mine causes it to read something.

Make sure your resistor is very close to the MPGuino-end of your wire.

EDIT: In answer to your question in the other thread, I have the diodes and resistors soldered to wires within an inch of the board.

Congrats on the successful build!